Fagor America FSV-144US Installation Instructions, Before Using Your Wine Cooler

Page 6

INSTALLATION INSTRUCTIONS

BEFORE USING YOUR WINE COOLER

Remove the exterior and interior packing.

Before connecting this appliance to the power source, let it stand upright for approximately 2 hours. This will reduce the possibility of a malfunction in the cooling system from handling during transportation.

Clean the interior surface with lukewarm water using a soft cloth.

INSTALLATION OF YOUR WINE COOLER

This appliance is designed to be for free standing installation or built-in (fully recessed).

Place your Wine Cooler on a floor that is strong enough to support it when it is fully loaded. To level your Wine Cooler, adjust the front leveling legs at the bottom of the Wine Cooler.

Locate the Wine Cooler away from direct sunlight and sources of heat (stove, heater, radiator, etc.). Direct sunlight may affect the acrylic coating and heat sources may increase electrical consumption. Extreme cold ambient temperatures may also cause the unit not to perform properly. Because of these factors this unit is not designed for use in a garage or any other outside installation.

Avoid locating the unit in moist areas.

Plug the Wine Cooler into an exclusive, properly installed-grounded wall outlet. Do not under any circumstances cut or remove the third (ground) prong from the power cord. Any questions concerning power and/or grounding should be directed toward a certified electrician or an authorized service center. This unit is not designed to be installed in a motor home or used with an inverter.

After plugging the appliance into an outlet, the unit should be allowed to cool for 3 ~ 4 hours before placing bottles in the appliance to ensure it reaches an appropriate, stable temperature.

BUILT – IN CABINET INSTRUCTIONS

This unit is designed for both built-in or free standing installation. If you plan to use this unit in a built- in application please follow the requirements shown below.

← Figure shown

Cabinet Opening Dimensions

 

IN (min)

MM (min)

Width

24”

610 mm

Depth

24”

610 mm

Height

35”

889 mm

 

 

 

Figure shown →

 

Unit Dimensions

 

 

 

IN (min)

MM (min)

Width

 

23 2/5”

589 mm

Depth

 

20 4/5”

528 mm

(without handle)

 

 

 

Depth

 

22 ¾”

578 mm

(with Handle)

 

 

 

Height

 

34 1/4”

870 mm

 

 

 

6

Image 6
Contents FSV-144US Manuel D’INSTRUCTION Manual DE InstruccionesTable of Contents Important Safety Instructions Wine Cooler SafetyImportant Safeguards Parts & Features Installation of Your Wine Cooler Installation InstructionsBefore Using Your Wine Cooler Built in Cabinet InstructionsElectrical Connection Extension CordSurge Protector Operating Your Wine Cooler Storage ShelvesCharcoal Filtration System Care and Maintenance Troubleshooting Guide Problem Possible Cause SolutionWiring Diagram Table DES Matières Fonctionnement DE L‟APPAREILConsignes DE Sécurité Importantes Sécurité Relative À L’APPAREILConseils DE Sécurité Importants Pièces ET Caractéristiques Preparation DU Cellier Préparation ET Installation DU CellierInstallation DU Cellier EncastrementBranchement AU Reseau ELECTRIQUE Avertissement  RallongeReglage DE LA Temperature Recommendations Relatives a LA TemperatureDeverrouillage DU Tableau DE Commande Fonctionnement DE L’APPAREILTablettes Éclairage InterieurCapacite D’ENTREPOSAGE Système DE Filtre AU CharbonEntretien DE L’APPAREIL Problème Cause Possible Solution Guide DE DépannageSchéma DE Câblage IC R O C O M P U T E R C O N T R O L LE RIndice Utilizacion DEL Armario BodegaInstrucciones DE Seguridad Seguridad DEL AparatoMedidas Preventivas Piezas Y Caracteristicas Instalacion DE SU Armario Bodega Instrucciones DE InstalacionAntes DE Utilizar SU Armario Bodega Instalacion IntegradaConexion Electrica Cable DE EXTENSION-ALARGADORProtector DE Sobretension Utilizacion DEL Armario Bodega Capacidad REPISAS/BALDASSistema DE Filtro DE Carbon Cuidado Y Mantenimiento Solucion DE Problemas Problema Causa Probable SolucionDiagrama Electrico