Fagor America FSV-144US instruction manual Troubleshooting Guide, Problem Possible Cause Solution

TROUBLESHOOTING GUIDE

You can solve many common Wine Cooler problems easily, saving you the cost of a possible service call. Try the suggestions below to see if you can solve the problem before calling the servicer.

PROBLEM	POSSIBLE CAUSE	SOLUTION
Cooler does not	Not plugged in.	Plug the unit in.
	The appliance is turned off.	Press to turn on the unit.
operate.
	The circuit breaker tripped or a blown fuse.	Check the breaker and/or fuses.
	External environment may require a higher
Cooler is not cold	setting.	Check the temperature control setting.
	The door is opened too often.	Close the door properly.
enough.
	The door is not closed completely.	Check the door gasket.
	The door gasket does not seal properly.
	The room temperature is hotter than normal.
	A large amount of contents has been added
The compressor	to the cooler.	Close the door properly.
turns on and off	The door is opened too often.
		Check the door gasket.
frequently.	The door is not closed completely.
	The temperature control is not set correctly.
	The door gasket does not seal properly.
The light does not	Not plugged in.	Plug in the unit.
	The circuit breaker tripped or a blown fuse.
work.		Check the breaker and/or fuses.
	The light button is “OFF”.
	The cooler is not levelled.	Check to assure that the cooler is level.
		Make sure the bottles don‟t touch	each
Vibrations.	The bottles are vibrating.
		other.
	There is an object under the cooler.
		Remove the object.
		Level the cooler.
		The rattling noise may come from the flow
The cooler seems to		of the refrigerant, which is normal. As each
		cycle ends, you may hear gurgling sounds
make too much	The cooler is not level.
		caused by the flow of refrigerant in	your
noise.
		cooler. Contraction and expansion of the
		inside walls may cause popping and
		crackling noises.
	The cooler is not level.	Level the cooler.
	The door was reversed and not properly
The door will not		Close the door properly.
	installed.
close properly.		Clean the door gasket.
	The gasket is dirty.
		Place the shelves properly.
	The shelves are out of position.
Error Code:
E0-E1-E2	Error codes.	Contact us for a service call.
HH-LL

11