GENERAL
SOUND ADJUSTMENT
Volume or tone adjustment does not affect recording.
VOLUME (VOL)
Press VOLUME N or M. The volume level is displayed as a number from 0 to MAX (25).
•The volume level is automatically set to 14 if the power is turned off when the volume level is set to 15 or more. (except when turning the power back on within 4 seconds)
•Pressing DISPLAY on the remote control displays the adjusted volume level
3-MODE EQUALIZER
Press *
The equalizer mode changes to R (Rock), P (Pop), J (Jazz) or no equalization, cyclically.
Rock - Emphasizes the high and low range of music. Pop - Emphasizes voice and midrange of music. Jazz - Emphasizes the low range of music.
* or EQ on the remote control
T-BASS system
The
Press
QSOUND system
This system provides a rich, three dimensional sound area for stereo sources.
You can enjoy more enhanced sound.
Press QSOUND and the QSOUND indicator lights up.
•At higher volumes, turning QSOUND on may cause sound distortion. In this case, make the volume down.
Maintenance
To clean the cabinet
Use a soft cloth lightly moistened with mild detergent solution. Do not use strong solvents such as alcohol, benzine or thinner.
To clean the heads
When the tape heads are dirty;
-high frequency sound is not emitted
-the sound is not adequately high
-the sound is
-the tape cannot be erased
-the tape cannot be recorded on
SETTING THE SLEEP TIMER
The unit can be turned off automatically at a specified time.
1 Keep REPEAT/SLEEP pressed until “30” flashes in the display.
2 Within 4 seconds, press r or tto specify the time until the power is turned off.
Each time it is pressed, the time changes between 10 and 90 minutes in
Specified time | While the sleep timer works, |
| the dot keeps flashing. |
To check the time remaining until the power is | En | |
turned off | ||
| ||
|
|
Repeat step 1 shown above. The remaining time is displayed for 4 seconds.
To cancel the sleep timer
Display the remaining time and press r or t repeatedly until OFF is displayed.
NOTE
If the unit is turned off during tape playback, x on the deck will not be released. Press Z to release x.
After every 10 hours of use, clean the tape heads with a head cleaning cassette.
Use separately sold
Refer to the instructions of the cleaning cassette for details.
Lens
To clean the lens
Use a cotton swab slightly moistened with cleaning fluid. Wipe gently from the center to the edge.