Installation Instructions
Installing the Exhaust Grill
With the oven now secured to the cabinet, install the Exhaust Grill by mounting it to the oven with the two screws provided.
NOTE:
You may need to loosen the side mounting screws a little to align the Exhaust Grill mounting holes. Tighten the side mounting screws after attaching the Exhaust Grill.
Exhaust Grill
#8 Screw 
Attaching the Exhaust Grill
Secure oven to cabinet with screws provided
Single Ovens – 4 screws
Double Ovens – 6 screws
Installing the Cabinet Mounting Screws
Reinstalling the Oven Doors
WARNING
WARNING – Failure to fully rotate the hinge catches will cause them to bend when the door is closed. This will make closing the door impossible.
Grasp the oven door on opposite sides and lift it until the door hinges are aligned with the openings in the oven frame. Holding the door at about a 30˚ angle from the horizontal, slide the hinges into the openings until the bottom hinge arms drop fully into the hinge receptacles. Lower the door to the fully opened position, and then rotate the two hinge catches toward the oven. Open and close the door completely to ensure that it is properly installed. For double ovens, complete Verifying Oven Operation for both the upper and lower doors.
For stainless steel ovens, peel off the protective layer of plastic that covers the door panel.
Verifying Oven Operation
Verifying Oven Operation
Slide the oven racks onto the support racks within the cavity. Place the broiler pan and tray on a rack within the oven, if desired.
Turn on the power supply to the oven. Set the time of day by pressing the Clock touch pad then pressing the TIME•TEMP key.
Press the BAKE selector pad for the upper oven or single oven. Select a temperature of 350˚F by pressing the TIME•TEMP “+” key. The oven should now be heating. After approximately three
(3)minutes, the lower heating element should glow red. Press the
CANCEL•SECURE pad to stop the oven heating process. It may take longer than three (3) minutes when ovens are running at voltages lower than 240V. If checking the operation of the double oven, repeat the bake test for the lower oven.
Press the BROIL selector pad for the upper oven or single oven. Select a temperature of 350˚F by pressing the TIME•TEMP “+” key. The oven should now be heating. After approximately three
(3)minutes, the upper heating element should glow red. Press the
CANCEL•SECURE pad to stop the oven heating process. It may take longer than three (3) minutes when ovens are running at voltages lower than 240V. If checking the operation of the double oven, repeat the broil test for the lower oven.
WARNING
WARNING – If the oven does not operate properly, follow these troubleshooting steps:
1.Verify that power is being supplied to the oven.
2.Check the electrical connections to ensure that the installation has been completed correctly.
3.Repeat the above bake test.
4.If the appliance still does not work, contact an authorized Dacor service company. If you are unable to locate a Dacor Servicer, please contact Dacor at (800)
9