INSTALLATION INSTRUCTIONS
Whilst every care is taken to eliminate burrs and raw edges from this product, please take care when handling - we recommend the use of protective gloves during installation.
Moving the cooker
Please note that the weight of this appliance is approximately 60kg (unpacked).
Take care if the appliance needs to be lifted during installation - always use an appropriate method of lifting.
Do not attempt to move the cooker by pulling on the doors or handles. Open the door and grasp the frame of the cooker, taking care that the door does not shut on your fingers.
Take care to avoid damage to soft or uneven floor coverings when moving the appliance. Some cushioned vinyl floor coverings may not be designed to withstand sliding appliances without marking or damage.
Clearances & dimensions
Appliance dimensions
All sizes are nominal, and some variation is to be expected. The ‘depth’ of the cooker, as given below, is to the front of the door and excluding knobs and handles.
depth:600mm
width:600mm
height (adjustable): 900 - 915mm
height with lid raised:1430 - 1445mm
Clearances
No shelf or overhang or cooker hood should be closer than a minimum of 650mm, but check with cooker hood manufacturer’s recommendations.
The cooker must have a side clearance above hob level of 90mm up to a height of 400mm.
Check that there are no projections in the rear wall which will prevent the lid (where fitted) being raised to the vertical position.
This cooker may be fitted flush to base units. However, for models with side opening doors, we recommend a side clearance of 60mm between the cooker and any side wall.
This is a type X appliance regarding installation requirements.
Important: Ensure that you route all mains cables well clear of any adjacent heat source.
22