INSTALLATION INSTRUCTIONS
Connect to the gas supply
The inlet to the cooker is 1⁄2” BSP internal situated at the rear right corner.
Fit the bayonet connection. This should be located so as to ensure that the flexible connector hose does not kink.
Use a
Ensure that all pipe work is of the correct rating for both size and temperature.
Flexible connections should comply with BS 669. Parts of the appliance likely to come into contact with a flexible connector have a temperature rise of less than 70˚C.
After installation, make sure all connections are gas sound.
Commissioning
Burner aeration
All burners have fixed aeration and no adjustment is possible.
Pressure setting
G20 Natural Gas @ 20 mbar
Pressure test point
Use the oven injector
Hob - Turn the control knob to the FULL ON position, wait a second before pressing the ignition switch or holding a lighted match or taper to the burner.
Before leaving the installation
1.Place all the loose parts of the cooker into position.
2.Show the customer how to operate the cooker and give them this handbook. Thank you.
25