AlfaSpid Rotator | www.alfaradio.ca | Page 6 |
Installation
Wiring Connections
The rotator unit must be wired to the control unit with
the distance between rotator and controller. The wire for the impulse
sensing may be quite thin - #22 or similar, even for relatively long distances.
Length | Gauge Motor |
| |||
10 m (32') | #18 (1.19 mm) | ||||
30 m (100') | #16 (1.42 mm) | ||||
60 m (200') | #14 (1.75 mm) | ||||
|
|
|
|
| |
|
|
|
| CAUTION!: | |
|
|
|
| ||
|
|
|
| ||
|
| Do not accidentally switch | |||
|
| the motor wires with the | |||
|
| impulse wires. Damage to | |||
|
| the control unit may occur! | |||
|
|
|
|
|
|
Remove cover from the motor body as shown and make connections as follows:
1 Motor Drive to 1 on controller terminal
2 Motor Drive to 2 on controller terminal
3 Impulse Sense to 3 on controller terminal
4 Impulse Sense to 4 on controller terminal
Page 6 of 21 Alfa Radio Ltd. 11211 - 154 St. Edmonton, Alberta, Canada T5M 1X8 780 466 5779