Operating Instructions, HOW to Start Unit

3. Press the SET button to enter the temperature into the control.

NOTE: Press the OVEN TEMP button at any time to view the actual oven temperature.

HOLDING TEMPERATURE

1. Press the HOLD button and the display will show the holding temperature.

2. Use the UP and DOWN buttons to set the desired temperature.

3. Press the SET button to enter the temperature into the control.

Press the START button and the display shows the remaining time in the cook/retherm cycle.

NOTE: The control will beep after it times down to zero and then automatically switches to the Hold mode. The display will then show the hold setpoint temperature.

FOR PROBE COOK OPERATION

Press the SELECT button to choose the probe mode.

PROBE TEMPERATURE

1. Press the PROBE/TIME button and the display will show the probe setpoint temperature.

2. Use the UP and DOWN arrows to set the desired temperature.

3. Press the SET button to enter the temperature into the control.

NOTE: Press the OVEN TEMP button at any time to view the actual oven temperature.

Press the START button and the display will show the actual probe temperature.

NOTE: The control will beep when the probe setpoint temperature has been reached and then automatically switches to the Hold mode. The display will then show the hold setpoint temperature.

Ovens		FL-2202-MP-M

Rev. 1 (4/08)		Page 4 of 10		5925 Heisley Road • Mentor, OH 44060-1833


			OPERATING INSTRUCTIONS
	POWER SWITCH		PRODUCT KEYS	CONTROL

ON	MODE	TIME - TEMPERATURE
ON		TIME - TEMPERATURE
	PROBE	TIMED
	SELECT	HEAT	COOK	HOLD
		OVEN	START	STOP
		TEMP

OFF

POWER

SETPOINTS

RETHERM

COOK

TIME

SET

PROBE

HOLD

Figure 1: Control Panel

(For parts description, refer to page 8.)

HOW TO START UNIT:

(for ﬁrst-time operation only)

A new oven needs to “burn off” factory oils and glue before it’s ﬁrst use. Do NOT load food into oven until this has been done!

1. Push power switch to “ON”.

2. Press the SELECT button and choose the TIMED mode.

3. Press the COOK BUTTON and set the temperature to 350° F (177° C).

4. Press the HOLD button and set the temperature to 150° F (66° C).

5. Press the PROBE/TEMP button and set the time to 1 hour.

6. Open upper door and move thumb screw on cabinet to open the cabinet vent.

7. Allow oven to run automatically for one hour of COOK/RETHERM cycle and 30 minutes of HOLD cycle.

HOW TO SET CONTROL:

FOR TIMED COOK OPERATION

Press the SELECT button to choose the Timed mode.

COOKING TIME

1. Press the PROBE/TIME button. The display will show the cook/retherm time.

2. Use the UP and DOWN arrows to set the desired time.

3. Press the SET Button to enter the time into the control.

COOKING TEMPERATURE

1. Press the COOK button and the display wil show the cook/retherm temperature.

2. Use the UP and DOWN arrows to set the desired temperature.

Call Toll-free: 877-CRES COR (273-7267) • Fax: 800-822-0393 • www.crescor.com

FL-2202-MP-M