Creda H150E manual Installation, Mains Connection, Siting the Cooker, Moving the Cooker

Page 5

Installation

WARNING – THIS APPLIANCE MUST BE EARTHED.

Mains Connection

Your cooker should have been checked to ensure that the voltage corresponds with your supply voltage, this is stated on the rating plate, which is situated on the rear panel.The cooker must be connected by a competent person such as one who is NICEIC registered contractor to suitable double-pole control unit with a minimum rating of 45A and a minimum contact

clearance of 3mm, which should be fitted adjacent to the cooker, in accordance with IEE regulations. The control unit must be within 2 metres of but not directly above the appliance and should be easily accessible in the event of an emergency.

The power supply cable should conform to B.S.6004 with a conductor size of 6mm2, minimum. Access to the mains terminals is gained by removing the rear access cover. The mains cable must pass through the cable clamp adjacent to the terminal block. Sufficient cable should be used to allow the cooker to be pulled out for servicing.

Ensure that the mains cable is routed away from any brackets affixed to the rear panel and is not trapped to the rear wall when pushing the cooker into position between cabinets.

Siting the Cooker

The cooker is designed to fit between kitchen cabinets spaced 500mm apart. The space either side need only be sufficient to allow withdrawal of the cooker for servicing. It can be used with cabinets one side or both as well as in an angled corner setting. It can also be used freestanding.

This cooker is a Type X appliance, as such adjacent side walls which project above hob level, must not be nearer to the cooker than 150mm and should be protected by heat resistant material. Any overhanging surface or cooker hood should not be nearer 650mm.

Moving the Cooker

Before moving your cooker, switch off at the cooker control unit, ensure that it is cool.

Open the grill door sufficiently to allow a comfortable grip on the underside front edge of the oven roof, avoiding any grill elements.

Radio Interference

This appliance conforms to EN 55014 regarding suppression of radio and television interference.

Note: Take care in moving the cooker as it is heavy. Take care to ensure that any floor covering is not damaged.

5

Page 4 Page 6
Image 5
Page 4 Page 6
Contents H150E Installation & User Instructions Creda Answer Centre 08701 54 64 Creda Answer Centre 08701 54 64Contents 89/336/EEC 73/23/EEC 92/31/EEC 93/68/EEC IntroductionDisposal of Your Product Mains Connection InstallationSiting the Cooker Moving the CookerAlways Safety InformationDo not Leave Deep FAT Frying Pans Unattended While Cooking Safety Advice in Case of a CHIP-PAN FireEvent of a chip pan fire or any other pan fire Extinguisher is likely to tip the pan overFeatures Control Panel Hotplates General Information Notes Control Settings GuideSafety requirements for deep fat frying Choice of Utensils Hob General InformationPans should not But essentially FlatOven Temperature Conversion ChartConvection Fan See chart on guide to grilling Setting the GrillGrill Grill pan handleGuide To Grilling Grill ChartFood Grill Setting Approximate Cooking time Oven Cookery Notes OvenOven Control To prepare meat for roasting in your electric ovenTemperature and Time Meat pan and rod shelves Food Temperature and Time Position in Oven Oven Temperature Chart MeatScones Oven Temperature Chart BakingRunners 1 Runner 4 fromBaking Problem Check GrillingCooking Results Not Satisfactory ‘CREDACLEAN’ Oven Liners Care and CleaningTo replace the oven door seal before using the appliance Dry with a soft clean clothOven Door Do not use scouring pads or abrasive powder which maySomething Wrong with your Cooker? Page For further product information 08701 54 64 Key Contacts
Top Page Image Contents