Daewoo KOR-61151, KOR-61155 service manual Fig. a

(1)Remove the gasket door ¤ from door plate ¤Œ.

(2)Remove the barrier screen inner ¤ºfrom door plate ¤Œ.

(3)Remove the door frame ¤Łfrom door plate ¤Œ.

(4)Remove the stopper hinge top ¤Øfrom door plate ¤Œ.

(5)Remove the spring ¤ and the hook ¤ .

(6)Remove the barrier screen outer ¤ from door frame ¤Ł.

(7)Remove the above steps for reassembly.

4.Method to reduce the gap between the door seal and the oven front surface.

(1)To reduce gap located on part ‘A’.

1)Loosen two screws on stopper hinge top, and then push the door to contact the door seal to oven front surface.

2)Tighten two screws.

(2)To reduce gap located on part ‘B’.

1)Loosen three screws on bottom hinge, and then the door to contact the door seal to oven front surface.

2)Tighten three screws.

A	D
B	C

(3)To reduce gap located on part ‘C’. (See Fig. A)

1)Loosen a screw on the interlock switch assembly located at the bottom of the oven body.

2)Draw the interlock switch assembly inward as possible to engage with hook on the door bottom.

3)Tighten a screw.

(4)To reduce gab located on part ‘D’.(See Fig. B)

1)Loosen a screw on the interlock switch assembly located at the top of the oven body.

2)Follow step (3) 2) and 3).

Secondary

Interlock

Switch

Hook	Mounting
	Screw

Hook

Mounting Screw

Primary

Interlock

Switch

Fig. A Fig. B

NOTE : A small gab may be acceptable if the microwave leakage does not exceed 4mW/cm2.

16