Daewoo KOC-1B4K owner manual Installation and Earthing Instructions, Child Lock

Page 3

INSTALLATION AND EARTHING INSTRUCTIONS

How to examine your microwave oven after unpacking.

Unpack oven, remove all packing material, and examine the oven for any damage such as dents, broken door, latches or cracks in the door. Do not remove the film from inside the door. Notify dealer immediately if the oven is damaged. Do not install if the oven is damaged.

Where to place your microwave oven.

1.Place the oven on a flat and stable surface.

2.Surface of the oven is protected by a plastic film which should be removed before using.

3.Leave space behind and sides and upper of the oven. All air vents should be kept a clearance.

If all vents are covered during operation, the oven may overheat and, eventually, lead to oven failure.

4.Keep away from radio and TV sets. If the oven is located close to a TV, radio interference may result.

5.Keep away from heating appliances and water taps. Keep the oven away from hot air, steam or splash when choosing a place to position it, or the insulation might be adversely affected and breakdowns occur.

6.The minimum height of free space necessay above the top surface of the oven is minimum 170mm.

Prior to use (If your oven has a grill element)

In order to protect your oven during transportation and storage, the grill element is covered with a protective coating. To remove this coating the grill element must be heated for 5 minutes. This procedure will produce some bad odours as the protective coating on the element disappears.

To remove the coating, use the following procedures:

1.Place an overproof and microwave safe bowl, containing 200cc of water or more, in the oven.

2.Press the convection button.

3.Set the time to 5 minutes.

4.Press the start button.

5.When the 5 minutes has elapsed, an acoustic signal sounds.

Note:

The protective coating has now been removed and the oven is ready to use. Please be aware that your oven now is very hot.

6.Open the oven door and remove the bowl with water (use oven gloves when removing the bowl).

CHILD LOCK

To prevent child from operating the oven, install the childlock key.

1.Touch more button for 3 seconds.

Indicator lock is indicated and all buttons do not operate.

2.Touch more button for 3 seconds once again, then childlock is canceled.

-WARNING: Only allow children to use the oven without supervision when adequate instructions have been given so that the child is able to use the oven in a safe way and understands the hazards of improper use.

Electrical Connection

WARNING-THIS APPLIANCE MUST BE EARTHED.

REFER TO RATING PLATE FOR VOLTAGE AND CHECK THAT THE APPLIANCE VOLTAGE CORRESPONDS WITH THE SUPPLY VOLTAGE IN YOUR HOME.

The flexible mains lead must be correctly connected, as below, to a three pin plug of not less than 13 AMP capacity. You must use a 3 pin plug which should be marked with the number BS 1363 and it should be fitted with 13 AMP fuse marked with the number BS 1362.

We recommend the use of good quality plugs and wall sockets that can be switched off when the machine is not in use.

IMPORTANT-The wires in the mains lead fitted to this appliance are coloured in accordance with the following code

GREEN AND YELLOW-EARTH

BLUE-NEUTRAL

BROWN-LIVE

As the colour of the wires in the mains lead of this appliance may not correspond with the coloured markings identifying the terminals in your plug, proceed as follows:

Power supply

•Check your local power source. This oven requires a current of approximately 12(8)amperes, 220V~240V 50Hz.

•Power supply cord is about 1.2 meters long.

•The voltage used must be the same as specified on this oven. Using a higher voltage may result in a fire or other accident

causing oven damage. Using low voltage will cause slow cooking. We are not responsible for damage resulting from use of this oven with a voltage of ampere fuse other than those specified.

•If the supply cord is damaged, it must be replaced by the manufacturer or its service agent or a similarly qualified person in order to avoid a hazard.

The wire which is coloured GREEN AND YELLOW must be connected to the terminal in the plug which is marked with the letter "E" or the earth symbol or coloured GREEN AND YELLOW, or GREEN.

The wire which is coloured BLUE must be connected to the terminal which is marked with the letter "N" or coloured BLACK, or BLUE.

The wire which is coloured BROWN must be connected to the terminal which is marked with the letter "L" or coloured RED , or

BROWN.

If the terminals in the plug are unmarked or you are in any doubt as to the correct connections, consult a qualified electrician.

If you do not make the proper electrical connections you will damage your microwave oven and possibly injure yourself. Neither the manufacturer nor the supplier are liable if this happens.

MOULDED PLUGS

Should it be necessary to remove a moulded on plug from the mains cable, it should be cut off and replaced with a suitable replacement.

The moulded plug cannot be used for any other appliance, therefore remove the fuse and dispose immediately and safely to prevent anyone, especially children from plugging it in to a wall socket, which will create a safety hazard.

Should the mains lead ever require replacement, it is essential that this operation be carried out by a qualified electrician and should only be replaced with a flexible cord obtained from the manufacturer.

Applicable only if moulded plug is fitted.

After replacement of a fuse in the plug, the fuse cover must be refitted. If the fuse cover is lost, a replacement cover is obtained. The colour of the correct replacement fuse cover is that of the coloured insert in the base of the plug or the colour that is embossed in words in the base of the plug recess or elsewhere on the plug. Always state this colour when ordering a replacement fuse cover.

Only 13 amp replacement fuses which are ASTA approved to BS 1362 should be fitted

2

Page 2 Page 4
Image 3
Page 2 Page 4
Contents Microwave CONVECTION/GRILL Oven Table of Contents Child Lock Installation and Earthing InstructionsGeneral Use Important Safety InstructonsLids Which Utensil can be Used in the OVEN?Eggs PiercingChild Lock indicator Control PanelAuto Defrost Press to select This metal rack is used with the turntable tray AccessoriesTurntable tray or turntable Metal rackSetting the Language Example To set Setting the ClockChild Lock and Power Save Mode To set power save modePower level table Percentage Output Microwave CookingTouch START/SPEEDY Cook button This methods is ideal for toasting bread or muffins Press Grill key Heating elements Display IndicatorGrill Cooking Suggested use Cookware220C Touch Convection button once. Convection indicator lightsConvection COOKINGwith pre-heat 160CConvection COOKINGtraditional cooking Use oven-proof cookwareScones, bread, puddings, large fruit cakes and all pastries Mode Elements Combination CookingCombination Cooking Microwave + Convection Combination Cooking Microwave + Convection + Lower Grill Combination Cooking Convection + Upper Grill + Lower GrillTouch Combi button twice Combination Cooking Microwave + Upper Grill Combination Cooking Microwave + Upper Grill + Lower GrillTouch Combi button 4 times Meat Auto DefrostIngredients Method Cookware Fruity Cream-cheese Cake CakeTouch Cake button once TwiceCarrot cake Ingredients Method Cookware Chocolate cakeApple pie Victoria SandwichStandard bread Dough Ingredients Method Cookware BiscuitsParty size sausage rolls Baked Jam Roly Poly PuddingMicrowave and Convection indicator light CrustyTouch Crusty button once Fresh Gratin Crusty Menu MethodFresh Pizza Frozen PizzaTouch Auto Cook button once Auto CookBaked Fish Roast BeefRoast Chicken Roast PorkTo set memory Memory CookSpeedy Cook LESS, MoreScroll Speed Scroll Speed Chart Press Crusty keyManual Cooling Scroll Speed ControlAbnormal Message To Stop the Oven While the Oven is OperatingGeneral Guide Lines Keep the Oven Clean Before Calling for Service ProblemSolution Specifications Questions and Answers

KOC-1B4K specifications

The Daewoo KOC-1B4K, a next-generation armored vehicle developed by Daewoo Defense Systems, represents a technological leap in military transport and combat capabilities. Designed to meet the demanding needs of modern warfare, this vehicle combines advanced armor protection, cutting-edge technology, and impressive mobility.

One of the key features of the KOC-1B4K is its multi-layered armor system. The vehicle is designed to withstand small arms fire, shrapnel, and even heavier projectiles, ensuring the safety of its occupants in hostile environments. The armor can be augmented with additional modules for enhanced protection, allowing it to adapt to various threats faced on the battlefield.

Powering the KOC-1B4K is a robust engine that provides exceptional mobility across diverse terrains. The vehicle is equipped with an advanced suspension system that allows for smooth operation on rough ground, making it suitable for both urban and off-road environments. The high ground clearance and powerful drivetrain also enable it to navigate obstacles efficiently and conduct operations in challenging conditions.

In terms of technology, the KOC-1B4K includes an integrated communication system that facilitates secure and reliable communication among the crew and with command units. This system is vital for coordinating missions and ensuring situational awareness on the battlefield. Additionally, the vehicle features advanced navigation systems, including GPS and inertial navigation, which enhance its operational effectiveness during missions.

Armament on the KOC-1B4K is adaptable, allowing for various configurations depending on mission requirements. Typically, it can be equipped with a remote-controlled weapon station, which may include machine guns or automatic cannons. This feature enables the crew to engage targets while remaining protected inside the vehicle.

The spacious interior of the KOC-1B4K can accommodate a small team of soldiers along with their equipment. The ergonomic design of the cockpit and the use of advanced displays and controls enhance crew comfort and operational efficiency. Furthermore, the vehicle is equipped with advanced detection and targeting systems that improve engagement capabilities and enhance combat effectiveness.

Overall, the Daewoo KOC-1B4K stands out as a formidable armored vehicle that embodies the fusion of protection, mobility, and advanced technology. Its versatile design ensures that it meets the diverse operational requirements of modern armies, making it a valuable asset on the battlefield. With its innovative features and robust characteristics, the KOC-1B4K is set to redefine standards in military armored vehicles.
Top Page Image Contents