Dacor IF48NBOL, EF48NBSS Water Supply Requirements, Water System Preparation, Water Pressure

Page 6

Refrigerator Operation

Water Supply Requirements

Read all directions before you begin.

IMPORTANT:

„„ When your refrigerator was installed, the water connection from the water source should have been connected to your refrigerator. If your refrigerator is not connected to a water source, see Connect the Water Supply in the installation instructions. If you have any questions about your water connection, see the Troubleshooting section or call a licensed, qualified plumber.

„„ If you turn the refrigerator on before the water line is connected, turn the ice maker OFF. See Ice Maker and Storage Bin on page 8.

„„ All installations must meet local plumbing code requirements.

Water Pressure

A cold water supply with water pressure between 30 and 120 psi (207 and 827 kPa) is required to operate the water dispenser and ice maker. If you have questions about your water pressure, see Troubleshooting or call a licensed, qualified plumber.

Reverse Osmosis Water Supply

IMPORTANT: The pressure of the water supply coming out of a reverse osmosis system going to the water inlet valve of the refrigerator needs to be between 30 and 120 psi (207 and 827 kPa).

If a reverse osmosis water filtration system is connected to your cold water supply, the water pressure to the reverse osmosis system needs to be a minimum of 40 psi (276 kPa).

If the water pressure to the reverse osmosis system is less than

40 psi (276 kPa):

„„ Check to see whether the sediment filter in the reverse osmosis system is blocked. Replace the filter if necessary.

„„ Allow the storage tank on the reverse osmosis system to refill after heavy usage.

„„ If your refrigerator has a water filter, it may further reduce the water pressure when used in conjunction with a reverse osmosis system. Remove the water filter. See Replacing the Water Filter on page 14.

If you have questions about your water pressure, call a licensed, qualified plumber.

Water System Preparation

Please read before using the water system.

Immediately after installation, follow the steps below to make sure that the water system is properly cleaned.

1.Open the freezer door and turn off the ice maker.

For non-dispensing models, lift the ice maker cover, then lift up the wire shutoff arm as shown below.

Ice maker cover

For dispensing models, move the switch to the OFF (right) setting as shown. The ON/OFF switch is located on the top right side of the freezer compartment. See below.

Ice Maker

NOTE: If your model has a base grille filter system, make sure the base grille filter is properly installed and the cap is in the horizontal position.

Do not use with water that is microbiologically unsafe or of unknown quality without adequate disinfection before or after the system. Systems certified for cyst reduction may be used on disinfected waters that may contain filterable cysts.

2.Use a sturdy container to depress the water dispenser bar until the water begins to flow. Flush the water system by dispensing and discarding 6 qt (5.7 L) of water. Cleaning the system will take approximately 3 to 4 minutes and will help clear air from the line. Additional flushing may be required in some households.

NOTE: As air is cleared from the system, water may spurt out of the dispenser.

3.Open the freezer door and turn on the ice maker. For non-dispensing models, lower the wire shutoff arm. For dispensing models, move the switch to the ON (left) position. „„Allow 24 hours to produce the first batch of ice.

„„Discard the first three batches of ice produced.

„„Depending on your model, you may want to select the maximum ice feature to increase the production of ice.

4

Page 5 Page 7
Image 6
Page 5 Page 7
Contents USE and Care Manual Inch and 48 Inch BUILT-INREFRIGERATORS Dacor, all rights reserved Important Safety Instructions Proper Disposal of Your RefrigeratorImportant Information Model IdentificationBefore Use Clean Before UsingTurning the Main Power Switch On/Off Refrigerator OperationWater Pressure Water Supply RequirementsWater System Preparation Reverse Osmosis Water SupplyNormal Operating Sounds Setting the ControlsOver Temperature Indicator Light Ensuring Proper Air CirculationWater Filter Monitor Setting the Temperature ScaleAdjusting the Temperature Setting Max CoolAlarms Water and Ice DispensersIce Maker and Storage Bin To Remove and Replace the Ice Bin non-dispensing models Clean the Ice Storage BinDispensing Models To Turn the Ice Maker On/OffIngredient Care Center Refrigerator StorageShelves and Shelf Frames Crispers and CoversFreezer Storage Freezer Baskets Power InterruptionsVacation Care Frozen Food Storage InformationCare and Cleaning CleaningChanging the Light Bulbs Using the Dispenser Without the Water Filter Replacing the Water FilterFlushing the Water System After Replacing Filter Troubleshooting Refrigerator will not operateIce maker is not producing ice or not enough ice Ice storage bin is difficult to remove Product Data Sheets Application Guidelines/Water Supply ParametersWarranty and Service Product MaintenancePage

EF42NBSS, EF48DBSS, IF42NBOL, IF48DBOL, EF48NBSS specifications

Dacor, a renowned name in luxury kitchen appliances, has made a significant impact with its impressive lineup of refrigeration products, including the IF48NBOL, EF48NBSS, IF48DBOL, IF42NBOL, and EF48DBSS models. Each of these refrigerators stands out for its combination of innovative technologies, modern aesthetics, and unparalleled performance, catering to both the practical needs and design preferences of today’s homeowners.

The Dacor IF48NBOL and IF48DBOL models are built with an emphasis on seamless integration. Their panel-ready design allows for customized front panels, enabling these appliances to blend effortlessly into any kitchen decor. Equipped with advanced preservation technology, these refrigerators utilize Dacor's Twin Cooling Plus system. This separates airflow between the refrigerator and freezer compartments, maintaining the ideal humidity levels that help keep food fresh for longer periods.

In contrast, the EF48NBSS and EF48DBSS models feature a stainless-steel finish that adds a touch of elegance and modern style to any kitchen. These freestanding refrigerators boast a robust and spacious design with an impressive capacity, perfect for storing a large number of groceries. The intelligent Touch Control panel allows users to conveniently adjust settings and monitor temperatures, ensuring optimal food preservation.

All of these Dacor models come equipped with advanced filtration systems, which help eliminate contaminants and unwanted odors, providing fresh-tasting water and ice. Their Energy Star certification highlights Dacor's commitment to sustainability, ensuring reduced energy consumption without compromising performance.

Another standout characteristic is the FlexZone Drawer found in many of these models, allowing for customizable temperature settings tailored to specific food items. This feature promotes versatility, accommodating anything from meats to produce, enhancing the overall user experience.

Finally, the sophisticated design is complemented by soft-close drawers, adjustable bins, and strategically placed LED lighting, providing easy access and visibility to all stored items. The combination of aesthetic appeal, innovative technology, and user-friendly features makes the Dacor IF48NBOL, EF48NBSS, IF48DBOL, IF42NBOL, and EF48DBSS refrigeration models a smart choice for those who value style and functionality in their kitchens.
Top Page Image Contents