Installation Instructions
Complete Installation
1.Turn the water supply line valve to the “Open” position.
2.Turn the refrigerator switch to the ON position. See Power On/ Off Switch in the use and care manual for instructions. Wait a few minutes. Check the water line connections for leaks.
3.Remove all boxes, parts packages and packing materials from the interior of the refrigerator. See the Care and Cleaning section in the use and care manual for instructions. Remove the film and cardboard from the grille and doors or door frame, depending on your model.
4.Install the shelves and bins in the refrigerator and freezer compartments.
5.The controls are preset at the factory to the midpoint setting. Check that the compressor is operating properly and that all the lights are working.
6.Flush the water system before use. See Water System Preparation.
To get the most efficient use from your new
Water System Preparation
Please read before using the water system.
Immediately after installation, follow the steps below to make sure that the water system is properly cleaned.
Do not use with water that is microbiologically unsafe or of unknown quality without adequate disinfection before or after the system. Systems certified for cyst reduction may be used on disinfected waters that may contain filterable cysts.
1.Open the freezer door and turn off the ice maker.
For
Ice maker cover
NOTE: If your model has a base grille filter system, make sure the base grille filter is properly installed and the cap is in the horizontal position.
2.Use a sturdy container to depress the water dispenser bar until the water begins to flow. Flush the water system by dispensing and discarding 6 qt. (5.7 L) of water. Cleaning the system will take approximately 3 to 4 minutes and will help clear air from the line. Additional flushing may be required in some households.
NOTE: As air is cleared from the system, water may spurt out of the dispenser.
3.Open the freezer door and turn on the ice maker. For non- dispenser models, lower the wire shutoff arm. For dispenser models, move the switch to the ON (left) position.
Allow 24 hours to produce the first batch of ice. Discard the first three batches of ice produced.
Depending on your model, you may want to select the maximum ice feature to increase the production of ice.
Any questions or problems with this installation should be directed to your Dacor dealer or the Dacor Customer Service Team at (800)
If you need service, be sure to have the model and serial numbers when you call. You’ll find these numbers on the serial number plate, located on the right hand side of the fresh food compartment.
Non-Dispenser Models
For dispenser models, move the switch to the OFF (right) setting as shown. The On/Off switch is located on the top right side of the freezer compartment.
Ice Maker
Dispenser Models
21