Danby DWC106A1BPDD manual Setting, Wine Storage, Shelf Instructions, To Remove a Shelf

OPERATING INTRUCTIONS (cont’d)

SETTING THE

TEMPERATURE Important: In the event of a power failure, wait 3 to 5 minutes before restarting.

•To switch the display between the Fahrenheit (°F) and Celsius (°C) scale, depress the ‘UP’ and ‘DOWN’ control buttons simultaneously for approximately five (5) seconds.

•The temperature range can be set as low as 43°F (6°C) or as high as 57°F (14°C) to suit your specific wine storage requirements. Each depression of the ‘UP’ or ‘DOWN’ buttons will allow you to adjust the temperature in 1° increments within the aforementioned range.

•You may view your ‘set’ temperature at any time by briefly depressing either the ‘UP’ or ‘DOWN’ button.

	WINE STORAGE	The DWC106A1BPDD has a maximum* capactiy of 75 (750mL) bottles of wine.
		* when stocked as per the below instructions.
To accommodate 75 bottles it will be necessary for			stacked alternately on top.
you to stock your wine cooler in the following way:			• The fourth and fifth shelves hold 6 bottles with one
• The first shelf holds 6 bottles arranged as per Fig. 3,
			bottle stored horizontally behind, as in Fig. 5.
with an additional bottle stacked on either side of the
controls, for a total of 8 bottles per the first shelf.			• The sixth through ninth shelves hold 6 bottles
• The second shelf holds 6 bottles arranged as per Fig.			arranged as per Fig. 3
3.			• The bottom of your wine cooler contains a 2-tier
• The third shelf holds 11 bottles when stacked as per			wooden rack which accommodates 6 bottles per rack,
			arranged as per Fig. 3; this allows for a total of 75
Fig. 4; 6 bottles across the shelf, with 5 bottles			(750mL) bottles of wine.

Fig. 3

Fig. 4

Fig. 5

SHELF	IMPORTANT!
INSTRUCTIONS	Do not cover any part of the shelves with aluminum foil or any other material that
	will prevent adequate air circulation within the cabinet.

To Remove a Shelf:

To remove a shelf from its locked position, tilt the shelf as shown in Fig. 6 and pull outward.

To Reinstall a Shelf:

To reinstall, ensure the shelf is resting securely on the support brackets and push the shelf inward until it locks in place.

Fig. 6

5