Dometic RMD 8555, RMD 8505 Installation recess, Securing the refrigerator, Recess dimensions

Installation

4.5Installation recess

The refrigerator must be installed draught-proof in a recess (also refer to Section "4.1.3"). The measurements of the recess are stated in the table below. Push the appliance far enough into the recess until the front edge of the refrigerator casing is aligned with the front of the recess. Allow a gap of 15-20 mm between the back wall of the recess and the refrigeration unit. The floor of the recess must be level, allowing the appli- ance to be pushed easily into its correct positi-

on. The floor must be substantial enough to bear the weight of the appliance. Ensure that the refrigerator is installed level in the recess.

4.5.1 Recess dimensions

Models

RMD 8501

RMD 8505

RMD 8551

RMD 8555

Height H	Width B	DepthT
1249 mm	529 mm	599 mm

4.6Securing the refrigerator

In the sidewalls of the refrigerator, there are four plastic sleeves for securing the refrigerator. The sidewalls or strips attached for securing the refrigerator must be prepared to hold the screws firmly in place even when under increased load (while the vehicle is moving). Fastening screws and caps are supplied with the refrigerator.

Fig. 27

CAUTION!

Always insert screws through the sleeves provided as otherwise components laid in foam, such as cables etc., could be dama− ged.

After the refrigerator is put in its final place, secure the screws into the wall of the recess. The screws must penetrate the casing of the refrige− rator.

Fig. 28

15