Whirlpool W10526071A installation instructions Level Range, Electronic Ignition System

Page 10

Level Range

1.Place rack in oven.

2.Place level on rack and check levelness of range, first side to side; then front to back.

3.If range is not level, pull range forward until rear leveling leg is removed from the anti-tip bracket.

4.Use wrench to adjust leveling legs up or down until range is level. Push range back into position.

5.Check that rear leveling leg is engaged in anti-tip bracket.

NOTE: Range must be level for satisfactory baking performance.

Electronic Ignition System

Initial lighting and gas flame adjustments

Cooktop and oven burners use pilotless igniters in place of standing pilots. When the cooktop control knob is turned to the “LITE” position, the system creates a spark to light the burner. This sparking continues, as long as the control knob is turned to “LITE.”

When the oven control is turned to the desired setting, a glow bar igniter heats and ignites the gas.

Check Operation of Cooktop Burners

Standard Surface Burners

Push in and turn each control knob to the “LITE” position.

The flame should light within 4 seconds. The first time a burner is lit it may take longer than 4 seconds to light because of air in the gas line.

If burners do not light properly:

Turn cooktop control knob to the “OFF” position.

Check that the range is plugged in and the circuit breaker has not tripped or the household fuse has not blown.

Check that the gas shutoff valve is set to the “open” position.

Check that burner caps are properly positioned on burner bases.

Repeat start-up. If a burner does not light at this point, turn the control knobs to “Off” and contact your dealer or authorized service company for assistance.

Adjust Flame Height

Adjust the height of top burner flames. The cooktop “LO” burner flame should be a steady blue flame approximately ¼" (0.64 cm) high.

A

B

A.Low flame

B.High flame

To adjust standard burners:

The flame can be adjusted using the adjustment screw in the center of the valve stem. The valve stem is located directly underneath the control knob.

If the “low” flame needs to be adjusted:

1.Light 1 burner and turn to lowest setting.

2.Remove the control knob.

Hold the knob stem in the low position using a pair of pliers. Use a ¹⁄₈" (3.0 mm) flat-blade screwdriver to turn the screw located in the center of the control knob stem until the flame is the proper size.

3.Replace the control knob.

4.Test the flame by turning the control from “LO” to “HI,” checking the flame at each setting.

5.Repeat steps 1 - 4 for each burner.

Check Operation of Both Oven Bake Burners

1.Press the BAKE keypad for the desired oven.

“BAKE” scrolls down in the upper text display area or scrolls up in the lower text display area, depending on oven selection, and 350°F is displayed. After 3 seconds “Set temp” scrolls in the selected oven text display area, followed by “Push START.”

2.Press START pad. “Baking” scrolls in the selected oven text display area. Then, after 3 seconds, “Preheating” scrolls in the display.

The igniter used to light the bake burner will glow. Once the igniter is hot, the oven bake burner should light. Under certain conditions, it may take up to 60 seconds for it to light.

If burners do not light properly:

Press OFF/CANCEL to turn off the oven.

Check that the range is plugged in and circuit breaker has not tripped or the household fuse has not blown.

Check that the gas shutoff valve is set to the “open” position.

Repeat start-up. If burner does not light, press OFF/CANCEL to turn off the oven and contact your dealer or authorized service company for assistance.

10

Image 10
Contents Instructions Pour L’INSTALLATION DES Cuisinières GAZ À Double Four DE 30 76,2 CMRange Safety Your safety and the safety of others are very importantTools and Parts Installation RequirementsLocation Requirements Product Dimensions Mobile Home Additional Installation RequirementsMobile home installations require Cabinet Dimensions Electrical RequirementsGas Supply Line Gas Supply RequirementsType of Gas Gas Pressure RegulatorInstall Anti-Tip Bracket Installation InstructionsAdjust Leveling Legs Unpack RangeTypical flexible connection Make Gas ConnectionFloor Mounting Wall Mounting Verify Anti-Tip Bracket Is Installed Engaged Complete connectionLevel Range Electronic Ignition SystemCheck Operation of Oven Broil Burner Complete InstallationIf you need Assistance or Service If range does not operate, check the followingLP Gas Conversion GAS ConversionsTo Convert Gas Pressure Regulator To Convert Oven Bake Burners To Convert Lower Oven Bake BurnerTo Convert Oven Broil Burner To Convert Upper Oven Bake BurnerNatural Gas Conversion LP Gas Orifice Spud Chart Burner Rating Color NumberTo Convert Surface Burners LP gas position Natural gas position Plastic cover 070 Natural Gas Orifice Spud Chart Burner Rating Color Number Sécurité DE LA Cuisinière Votre sécurité et celle des autres est très importanteOutils nécessaires Exigences D’INSTALLATIONOutils et pièces Pièces fourniesDimensions du produit Exigences d’emplacementDimensions du placard Spécifications électriques Type de gaz Spécifications de l’alimentation en gazCanalisation de gaz Détendeur de gazRéglage des pieds de nivellement Instructions DinstallationDéballage de la cuisinière Débit thermique des brûleursRaccordement typique par raccord flexible Installation de la bride antibasculementRaccordement au gaz Montage au plancher Montage au murAchever le raccordement Allumage initial et réglages des flammes de gaz Réglage de laplomb de la cuisinièreSystème dallumage électronique Si les brûleurs ne sallument pas correctementContrôle du fonctionnement du brûleur du gril Achever l’installationSi vous avez besoin dassistance ou de service Si les brûleurs ne sallument pas correctementConversion pour lalimentation au propane Conversions Pour Changement DE GAZConversion du détendeur Conversion des brûleurs de cuisson au four Conversion du brûleur de cuisson au four inférieurConversion du brûleur du gril Conversion du brûleur de cuisson au four four supérieurConversion des brûleurs de surface Conversion pour lalimentation au gaz naturel Conversion du brûleur de cuisson au four four supérieur Conversion du brûleur du gril Chapeau de brûleur Page Page Page W10526071A

W10526071A specifications

The Whirlpool W10526071A is a highly innovative appliance designed to enhance your cooking experience while providing exceptional versatility and functionality. As a part of Whirlpool’s commitment to creating smarter and more efficient kitchen solutions, this product integrates advanced technologies that cater to the needs of modern households.

One of the standout features of the W10526071A is its spacious design, which allows ample room for cooking various dishes simultaneously. This appliance is equipped with multiple cooking modes, including baking, broiling, and warming, ensuring that users can choose the best method for their culinary needs. Its user-friendly interface is intuitively designed, allowing for easy navigation between settings and functions so that even novice cooks can maximize their potential.

The W10526071A boasts advanced temperature management technology, ensuring consistent heat distribution throughout the cooking space. This feature helps to eliminate hot spots, resulting in evenly cooked meals every time. Additionally, the appliance includes a built-in timer and automatic shut-off feature, providing peace of mind for busy cooks who may step away from the kitchen.

Ease of cleaning is another critical aspect of the Whirlpool W10526071A. The interior surfaces are coated with a non-stick finish, which simplifies the cleaning process and ensures that spillages and splatters do not become a hassle. A removable crumb tray further enhances convenience, allowing for easy disposal of mess without needing to disassemble the unit.

Furthermore, this appliance has been designed with energy efficiency in mind. It utilizes advanced insulation technology to minimize heat loss, leading to lower energy consumption. This characteristic not only reduces utility bills but also contributes to a more environmentally friendly kitchen.

Whirlpool is renowned for its durability and reliability, and the W10526071A continues that legacy. Constructed from high-quality materials, this appliance is built to withstand the rigors of daily use, ensuring a long lifespan and dependable performance.

In summary, the Whirlpool W10526071A combines innovative features, advanced technologies, and user-centric design to create a powerful kitchen appliance. Its spacious cooking capacity, precise temperature management, ease of cleaning, and energy efficiency make it an excellent addition for any home chef looking to elevate their culinary creations. With Whirlpool, cooking becomes not just a necessity, but a delightful experience.