Electrical Requirements, Cabinet Dimensions

Cabinet Dimensions

Cabinet opening dimensions shown are for 25" (64.0 cm) countertop depth, 24" (61.0 cm) base cabinet depth and 36" (91.4 cm) countertop height.

IMPORTANT: If installing a range hood or microwave hood combination above the range, follow the range hood or microwave hood combination installation instructions for dimensional clearances above the cooktop surface.

Range may be installed with zero clearance to combustible construction at the rear and on the sides below the cooktop.

	B		D
	C
A	E
	E
F	J	I	G
	J		G
	K
	K	L
		L
			H
			8½"
			(21.6 cm)

14"

(35.6 cm)

1½"	2¼" (5.7 cm)
(3.8 cm)	2¼" (5.7 cm)
	1¼"*
	(3.1 cm)
	8½" (21.6 cm)**
	gas line location

A. 18" (45.7 cm) upper cabinet to countertop B. 13" (33.0 cm) upper cabinet depth

C. 30" (76.2 cm) min. opening width

D. For minimum clearance to the top of the cooktop, see NOTE. E. 30" (76.2 cm) min. opening width

F. 3" (7.6 cm) min. clearance from both sides of the range to the side wall or other combustible material.

G. Cabinet door or hinges should not extend into the cutout. H. 3" (7.6 cm) distance from wall

I. 1¹⁄₂" (3.8 cm) min. from right side cabinet J. 8" (20.3 cm) width

K. 7" (17.8 cm) min. from floor L. 2" (5.1 cm) min. from floor

*Drill on centerline 1¼" (3.1 cm) from rear wall for gas supply line.

**Gas lines must be installed within the shaded area to ensure proper alignment of this oven with cabinets.

***Electrical plugs must be installed within the shaded area to ensure proper alignment of this oven with cabinets.

NOTE: 24" (61.0 cm) minimum when bottom of wood or metal cabinet is covered by not less than ¹⁄₄" (0.64 cm) flame retardant millboard covered with not less than No. 28 MSG sheet steel, 0.015" (0.4 mm) stainless steel, 0.024" (0.6 mm) aluminum or 0.020" (0.5 mm) copper.

30" (76.2 cm) minimum clearance between the top of the cooking platform and the bottom of an uncovered wood or metal cabinet.

Electrical Requirements

WARNING

Electrical Shock Hazard

Plug into a grounded 3 prong outlet.

Do not remove ground prong.

Do not use an adapter.

Do not use an extension cord.

Failure to follow these instructions can result in death, fire, or electrical shock.

IMPORTANT: The range must be electrically grounded in accordance with local codes and ordinances, or in the absence of local codes, with the National Electrical Code, ANSI/NFPA 70 or Canadian Electrical Code, CSA C22.1.

If codes permit and a separate ground wire is used, it is recommended that a qualified electrical installer determine that the ground path is adequate.

A copy of the above code standards can be obtained from:

National Fire Protection Association

1 Batterymarch Park

Quincy, MA 02169-7471

CSA International

8501 East Pleasant Valley Road

Cleveland, OH 44131-5575

■A 120 volt, 60 Hz., AC only, 15-amp fused, electrical circuit is required. A time-delay fuse or circuit breaker is also recommended. It is recommended that a separate circuit serving only this range be provided.

■Electronic ignition systems operate within wide voltage limits, but proper grounding and polarity are necessary. Check that the outlet provides 120-volt power and is correctly grounded.

■The wiring diagram is located on the back of the range in a clear plastic bag.

W10526071A specifications

The Whirlpool W10526071A is a highly innovative appliance designed to enhance your cooking experience while providing exceptional versatility and functionality. As a part of Whirlpool’s commitment to creating smarter and more efficient kitchen solutions, this product integrates advanced technologies that cater to the needs of modern households.

One of the standout features of the W10526071A is its spacious design, which allows ample room for cooking various dishes simultaneously. This appliance is equipped with multiple cooking modes, including baking, broiling, and warming, ensuring that users can choose the best method for their culinary needs. Its user-friendly interface is intuitively designed, allowing for easy navigation between settings and functions so that even novice cooks can maximize their potential.

The W10526071A boasts advanced temperature management technology, ensuring consistent heat distribution throughout the cooking space. This feature helps to eliminate hot spots, resulting in evenly cooked meals every time. Additionally, the appliance includes a built-in timer and automatic shut-off feature, providing peace of mind for busy cooks who may step away from the kitchen.

Ease of cleaning is another critical aspect of the Whirlpool W10526071A. The interior surfaces are coated with a non-stick finish, which simplifies the cleaning process and ensures that spillages and splatters do not become a hassle. A removable crumb tray further enhances convenience, allowing for easy disposal of mess without needing to disassemble the unit.

Furthermore, this appliance has been designed with energy efficiency in mind. It utilizes advanced insulation technology to minimize heat loss, leading to lower energy consumption. This characteristic not only reduces utility bills but also contributes to a more environmentally friendly kitchen.

Whirlpool is renowned for its durability and reliability, and the W10526071A continues that legacy. Constructed from high-quality materials, this appliance is built to withstand the rigors of daily use, ensuring a long lifespan and dependable performance.

In summary, the Whirlpool W10526071A combines innovative features, advanced technologies, and user-centric design to create a powerful kitchen appliance. Its spacious cooking capacity, precise temperature management, ease of cleaning, and energy efficiency make it an excellent addition for any home chef looking to elevate their culinary creations. With Whirlpool, cooking becomes not just a necessity, but a delightful experience.