Install properly.. . ,iT=TfI-l
1Allow ‘/2” [ 2 cm) space on each side and at top for ease of lnstallatlon
2.If the refrigerator is to be against a wall, you must
leave enough space for the
3 The refrigerator back can be flush against the wall
Level refrigerator-freezer.. .
Use Screwdriver
1 Remove base grille (see page 11)
2 To raise front, turn each screw to the right.
3.To lower front, turn each screw to the left
4Check with level.
Clean it...
Clean your refrigerator before using it See clean- ing instructtons on page 11
Plug it in...
grounding type wall receptacle
Refrigerator
Power Cord
Recommended
Grounding Method
| A 115 Volt, 60 | Hz, | AC only. 15 or 20 ampere | fused | ||||
electrical | supply | IS required | It IS recommended | that | ||||
a | separate | circuit | serving | only | this | appliance | ||
be | provided |
|
|
|
|
|
|
|
| Do not use an extension | cord Use | a | receptacle | ||||
which cannot be turned off with a switch or pull
chain. See Individual electrlcal requirements and
grounding instructton sheet in your literature package
When you plug In the refrigerator...
l | Symbols | on the | Performance | Monitor | ~111glow | ||
l | You | may | hear | a soft | beeping | sound | (8 beeps |
| every | 2 minutes) | This | IS normal |
|
| |
Remove sales labels.. .
Remove the Consumer Buy Guide label and any
Inside sales labels before using the refrigerator Re- move any left over glue with rubbing alcohol.
Note: DO NOT REMOVE the two labels 1InsIde
the Uttlllty Compartment. They are permanent InstructIons for using the SYSTEMS SENTINEL‘
Performance Monitor.
(Own1
To stop the beeplng,
I. Open the refrigerator door.
2.Locate the AUTO SCAN Switch (top of door]
3.Move the switch to RESET.
When the refrigerator has cooled, move the AUTO SCAN Switch back to NORMAL. [See page b for
more information on the AUTO SCAN Switch and the
SYSTEMS SENTINEL* Performance Monitor.)
‘TMK
4Sl
Permanent lnformatlcn Labels