Secondary Installation

Figure 55. Hook Fan Tabs Over Grommets at Unit Back.

Installation of Kit:

1.Ensure the appliance is turned off and cool.

2.Remove the bottom louvers.

3.Place fan in lower area of unit behind the controls (see Figure 54).

4.Hook the two (2) slots on the fan box over the two (2) grommets on the back wall, refer to Figure 55.

5.Using two (2) T-20 screws, attach the fan control box to the ignitor control panel, refer to Figure 56. Before tightening the screws ensure that the thermal switch on top of the box firmly contacts the firebox bottom.

6.Plug the fan into the hard wired electrical box/outlet (refer to Figure 57) that was installed in the

“INITIAL INSTALLATION - INSTALLATION OF ELECTRICAL OUTLET FOR OPTIONAL FAN KIt“.

Figure 56. Install Fan Control Box.

Figure 57. Plug In Fan Kit.

34

Page 33 Page 35
Page 34
Image 34
Enviro DV36 owner manual Installation of Kit, Hook Fan Tabs Over Grommets at Unit Back
Page 33 Page 35
Top Page Image Contents