Whirlpool ED25YQ warranty Before Using Your Refrigerator, Cleaning it, Plugging it

Page 5

Before Using Your

Refrigerator

In This

Section

Page

 

 

Page

 

 

 

 

Cleaning

R

.......5

lnstalllng

tt properly

.......6

Plugging

lt In

.......5

Leveling

lt

.......6

It is important to prepare your refrigerator for use. This section will tell you how to clean it, connect it to a power source, install it and level it.

Cleaning it

Removing packaging materials

Remove tape and any inside labels (except the model and serial number label) before using the refrigerator.

To remove any remaining glue:

l Rub briskly with thumb to make a ball, then remove.

OR

l Soak area with liquid hand-dishwashing detergent before removing glue as described above. Do not use sharp instruments, rubbing alcohol, flammable fluids or abrasive cleaners. These can damage the material. See “Important Safety Instructions” on page 3.

NOTE: Do not remove any permanent instruction labels inside your refrigerator. Do not remove the Tech Sheet fastened under the refrigerator at the front.

Cleaning it before use

After removing all packaging materials, clean your refrigerator before using it, if necessary. See cleaning instructions on pages 20-21.

Plugging it in

Recommended Grounding Method

A 115 Volt, 60 Hz., AC only 15 or 20 ampere fused and properly grounded electrical supply is required. It is recommended that a separate circuit serving only this appliance be provided. Use a receptacle which cannot be turned off with a switch or pull chain. Do not use an extension cord.

See Electrical Requirements and Ground- ing Instructions Sheet in your Literature Package.

3-prong grounding type wall receptacle

Refrigeretor power cord

grounding plug

5

Image 5
Contents Model ED25YQ Thank you for buying a Whirlpool appliance Your safety is important to usHelp us help you Important Safety InstructionsControl panel Parts And FeaturesPlugging it Before Using Your RefrigeratorCleaning it Leveling it Installing it properlyThis Section Using Your RefrigeratorSetting the controls Changing the control SettingsRemoving the door shelf fronts ConditionRemoving the door trim dispenser area Adjusting the refrigerator shelvesRemoving the crisper Adjusting the crisper humidity controlCrisper cover To remove the coverRemoving the meat drawer and cover Adjusting the meat drawer temperatureRemoving the snack BinRemoving the freezer shelf Adjusting the wine rackRemoving the freezer Personal Injury Hazard Thirstcrusher dispensing systemWater dispenser Using the automatic ice makerDispenser Light To dispense waterTo remove ice bin Removing the ice maker storage binCause Solving common dispenser problemsProblem Changing the light bulbs Removing the base grilleSlight hum, soft hiss Understanding the sounds you may hearWater sounds Ice maker soundsSaving energy HOW to Clean Cleaning your refrigeratorCaring For Your Refrigerator PartWarm water Door liners and gaskets Plastic partsDefrost pan Condenser coils Floor under refrigerator Care Power interruptionsVacation and moving Storing fresh food Food Storage GuidePackaging Storing frozen foodFreezing Packaging recommended for useSolution If You Need Assistance Or ServiceBefore calling for assistance Lights do not work Ice maker will not operateRemember Motor swms to run too muchIf you are not satisfied with how the problem was solved If you need serviceIf you need assistance If you need FSP replace- ment partsWhirlpool Refrigerator Warranty