QSC Audio DCA Series user manual MOUNTING- All Models, Mounting the Accessories

MOUNTING- All Models

Mounting the Accessories

An accessory may be mounted with the amplifier either in or out of the rack, even if the amp is installed with rear rack ears.

1.Turn off the amplifier before installing the accessory.

2.Make sure the SIP resistor networks are installed properly and no SIP sockets are empty.

3.Line up the HD-15 connector on the accessory with the amplifier’s DataPort, then press the accessory onto the back of the amplifier so that the HD-15 connector inserts into the DataPort.

4.Use the three screws supplied to secure the accessory to the amplifier chassis, as shown below. Two long screws go into the holes near the DataPort, while the short screw goes through the hole in the tab on the right edge of the accessory. Do not overtighten the screws.

5.Attach the input and output cables to the appropriate connectors on the accessory. Use the amplifier’s normal output connectors for attaching speaker and monitor cabling.

12