Whirlpool ET1 8JKXL Using your refrigerator, Controls ’ ..’ ’ j, Removing Non-Adjustable Shelves

Using your refrigerator

Light Switch Freezer Control

\Set_ on B

Settlng

the

Controls.

*’ ..’

.’ j

The

Refrigerator

and Freezer Controls are on a console inside the

refrigerator

at

the

top.

To start

the

refrigerator,

set

the

Refrigerator

Power Savmg Control

Control

to 3 and

the

Freezer

Control

to B.

until

the

Insides

are

When

you

first

turn

it on,

it will

run continuously

properly

cold.

It takes

time

for

your

refrigerator

and

freezer

to get

cold

enough

to

store

food

safely.

Before

loading

it with

food,

be

sure

the refrigerator

motor

has

cycled

at

least

once

[turned

on, turned

off,

and turned on again). This may take up to a day.

The

following

chart

gives

recommended

cont:ol

settings

for a

number

of operating

conditions.

OPERATING									RECOMMENDED
CONDITIONS									CONTROL	SETTINGS
For Normal			Use:						Refrigerator		3
-Normal			number of door					openings.
-Normal			amounts			of food		added.	Freezer..		B
-	Normal		room		temberature.
If Refrigerator				Section		is Too		Warm:	Refrigerator		4
-Door		opened			often.
-Large,		warm			food	load	added.		Freezer..		C
-Room temaerature						verv		warm.
If Freezer Section is Too Warm:									Refrigerator		3
-	Door	opened			of-ten.
-Large		amount			of warm		food added.		Freezer..		A
-Very cold room temperature.
If Ice isn’t Made Fast Enough:									Refrigerator		3
-Heavy		ice		usage.
-Cold		room		temperature.					Freezer..	.	A
If Both Sections are Too Warm:									Refrigerator	. . . 4
-Doors		opened			often.
-Large		amounts			of	food	added.		Freezer..		B
-Very warm or cold room temperatures.
POWER SAVING CONTROL: It’s normal for
moisture to form around the doors when
room	humidity			is high.
-	If moisture			forms.					REDUCES EXTERIOR
-If no moisture forms...room humidity is									MOISTURE
low or during			heating			season			CONSUMES	LESS
									ENERGY

The temperature setting will be about right when milk or juice are as cold as you like, and when ice cream is firm. If you need to adjust the settings to match the way your refrigerator is used, use the set- tings suggested in the chart above. Change only one control at a time. Wait o day, then make mother change, if needed.

	Removing		Non-Adjustable	Shelves.
	To remove a shelf, lift up the front. Then lift up at the back. To
	replace	it, put	the rear notches	onto the shelf supports. Lower the
Then the Back	front into	place.

4