Whirlpool ETWM ws manual Install properly Remove sales labels, Clean it, Do not

Install properly.. . Remove sales labels.. .

rII-

I/

Remove the Consumer Buy Guide label, tape and

	any inside labels before using the refrigerator
	To remove any remaining glue:
	I. Rub briskly with thumb to make a ball then remove
	OR
	2 Soak area with dishwashing detergent solution (1
	teaspoon		detergent		in 1 quart	warm	water) before
0	removing		glue	as described		in step	1.
	DO NOT		USE rubbing		alcohol	or flammable		or
	toxic solvents, such as acetone, gasoline, car-
	bon	tetrachloride,		etc. These		can	damage	the
	material.
	NOTE: DO NOT REMOVE ANY PERMANENT IN-
	STRUCTION LABELS INSIDE YOUR REFRIGERATOR.
	Do not remove the Tech Sheet fastened under
	the	refrigerator		at the	front.
	Clean it.. .			-’		A f

1.Allow 3 inches (7.5 cm) between overhead cab- inets and the refrigerator top.

2.Allow at least an inch (2.5cm) between the refrig- erator condenser and the wall.

3.Allow J/ZInch (1.25 cm) on each side of the re- frigerator for ease of installation.

4.If the refrigerator is to be against a wall, you might want to leave enough space so the door can be opened wider.

Clean your refrigerator before using it. See clean- ing instructions on pages 7 and 8.

Plug it in...

Level refrigerator-freezer.. .

1.Keep the 4 bolts that hold refrigerator In shipping crate. They are the levelling legs.

2.Screw these bolts all the way into bolt holes at the bottom corners of refrigerator. Roll refrigerator into place.

3.Lower legs just enough to lift rollers off floor.

4.Adjust each until the refrigerator won’t rock.

5.Adjust front legs to level the refrigerator.

-To raise corners, turn legs counterclockwise. -To lower corners, turn legs clockwise.

6.Check with level.

4

Refrigerator

Power Cord

RECOMMENDED GROUNDING METHOD

A 115 Volt, 60 Hz., AC only 15 or 20 ampere fused

and properly grounded electrical supply IS re-

quired. It IS recommended that a separate circuit serving only this appliance be provided.

Do not use an extension cord. Use a recep- tacle which cannot be turned off with a switch or pull chain. See individual electrrcal requrre- ments and grounding instruction sheet in your Irter- ature package.