Terminal Block Connector

The terminal block connector requires the following assembly.

1.Strip the wires to 7 ~ 8 mm.

2.Insert the wires into the male part of the connector according to the Mode you are using. See below.

3.Use a flat-tip screwdriver to secure the wires. Tighten the screws to 6 in.-lbs.

4.Insert the plug into the receptacle on the amplifier.

5.Use a flat-tip screwdriver to secure the connector. Tighten the screws to 6 in.-lbs.

Stereo and Parallel Mode: Wire as shown by loudspeaker symbols 1 and 2, and the solid wires in (Figure 30).

Bridge Mode: Wire as shown by Bridge Mono loudspeaker symbol, and the dashed wires in (Figure 30).

– Figure 30 –

Terminal Block Connector Wiring	UL	IEC
Wire range	-	6 mm2

Solid wire (AWG)	28 – 10	-

Stranded wire (AWG/mm2 )	28 – 10	-

Torque (lb.-in.)	6	-

Wire strip length	7 – 8 mm	-

– Table 3 –