Operating Voltage
(AC Mains)
Make sure you connect the amplifier to the correct AC line voltage, as shown on the serial number label. Connecting to the wrong line voltage is dangerous and may damage the amplifier (Figure 31).
– Figure 31 –
Operation
AC Power Switch
Before applying power, check all connections and turn the attenuation controls fully counter clockwise to maximum attenuation. One second of muting is normal when the amp is turned on or off (Figure 32).
Attenuation Controls
The controls are marked with a scale indicating attenuation. Maximum attenuation is fully counter clockwise, minimum attenuation is fully clockwise. (Figure 33).
LED Indicators
The green SIGNAL LED indicators light at approximately 0.1% of full power. The red CLIP LED indicator flashes during overload (clipping).
If the amplifier's protection circuitry triggers protective muting, the signal and clip LEDs will not light. If this occurs during use, see the Troubleshooting section on pages 16 — 17.
On |
|
– Figure 32 – | – Figure 33 – |
Model Maximum Voltage Gain
CMX 300V | 31.6 x (30 dB) |
|
|
CMX 500V | 40 x (32 dB) |
|
|
CMX 800V | 46 x (33 dB) |
|
|
– Table 4 –
15