Raise slgnal arm to stop Ice.
Lower slgnal arm to start If
To dispense water:
1.Press a sturdy glass against the water dispenser bar.
2.Remove glass to stop dispensing.
NOTE: Dispense enough water every week to maintain a fresh supply.
Chilled water comes from a tank behind the meat drawer. It holds about 1‘h quarts (1.5 L).
When the refrigerator is first hooked up, press the water dispenser bar with a glass or jar until you have drawn and discarded 2 or 3 quarts (1.9 to 2.8 L) of water. The water you draw and discard will rinse the tank and pipes.
Allow several hours to chill the first tankful. NOTE: The small tray beneath the dispenser is designed to evaporate small spills. There is no drain in this tray. Do not pour water into it.
To turn on nlght Ilght, slide dispenser LIGHT switch to the left. See page 9 for directions for changing the dispenser light bulb.
Automatlc ke maker
Here are a few things you will want to know about your automatic ice maker:
l The ON/OFF lever is a wire signal arm. Down ... for making ice automatically.
up ... to shut off the ice maker.
.. . .
PJOTF Do not turn ice maker on until It 1s aonnected
or Ice mwcllter SUDDL~
llt is normal for ice crescents to be attached by a corner. They will break apart easily.
l The ice maker will not operate until the freezer is cold enough to make ice. This can take overnight.
llf ice is not being made fast enough and more ice is needed, turn the Refrigerator Control toward a higher number. Wait a day and, if necessary, turn the Freezer Control toward C.
l Good water quality is important for good ice quality. lt is not recommended that the ice maker be connected to a softened water supply. Water softener chemicals such as salt from a malfunctioning softener can damage the ice maker mold and lead to poor quality ice. lf a softened water supply cannot be avoided, then if is important that the water softener be well maintained and operating properly.
11