Install properly.. .
I
I=-
E
1.Allow % inch (1.25 cm] space on each side and at the top of the refrigerator for ease of installation
2.If the refrigerator ISto be against a wall, you might want to leuve extra space so the door can be opened wider
3.The refrigerator back can be flush against the wall.
Level refrigerator-freezer.. .
Right to Raise:
Left to Lower
I, Remove base grille (see page 7 1,
2.To raise front, turn each screw to the right.
3.To lower front, turn each screw to the left.
4.Check with level.
Remove sales labels.. .
Remove the Consumer Buy Guide label, tape and any inside labels before using the refrigerator.
To remove any remaining glue:
1.Rub briskly with thumb to make a ball then remove.
OR
2.Soak area with dishwashing detergent solution (1 teaspoon detergent in 1 quart warm water] before removing glue as described in step 1.
DO NOT USErubbing alcohol or flammable or toxic solvents, such as acetone, gasoline, car- bon tetrachloride, etc. These can damage the material.
NOTE: DO NOT REMOVE ANY PERMANENT IN- STRUCTION LABELS INSIDE YOUR REFRIGERATOR.
Do not remove the Tech Sheet fastened under the refrigerator at the front.
am.
w
Clean it.. .
Clean your refrigerator before using it.
See cleaning instructions on page 9.
Plug it in...
&prong grounding type wall receptacle
Retrigerator | grounding | plug |
Power Cord |
|
|
RECOMMENDED GROUNDING METHOD
A 115 Volt, 60 Hz., AC only 15 or 20 ampere fused
and properly grounded electrical supply is re-
quired. It is recommended that a sepurate circuit serving only this appliance be provided.
Do not use an extension cord. Use a recep- tacle which cannot be turned off with a switch or pull chain. See individual electrlcal requlre- ments and grounding instruction sheet in your liter- ature package.
4