Whirlpool DU3040XP manual Before starting your, Changing a setting

Option Selector Switch

Before starting your

1.Spin the Upper Spray Arm to make sure nothing will stop it from turning freely.

2.Close and latch the door.

dishwasher

3.Run hot water at sink nearest dish- washer until it is hot. Turn it off. (If yours is a portable dishwasher, see page 14

for connecting instructions.)

Starting your dishwasher

NORMAL HEAVY Cvcle...

Make sure Cycle control Knob points to dot marked NORMAL HEAVY.

Select option.

Without turning it, pull the Cycle Con- trol Knob out to start the Cycle.

rinse

NORMAL LIGHT Cycle...

1.Turn Cycle Control Knob until it stops at dot marked NORMAL LIGHT.

2.Select option.

3.Without turning it, pull the Cycle Con- trol Knob out to start the Cycle.

Changing a setting

You can change a setting anYtime during any cycle.

1. Unlatch the doorto stop the cycle.

RINSE & HOLD Cycle...

1.Select AIR DRY Option only.

2.Unlatch door and open slightly.

3.Pull Cycle Control Knob out.

4.Turn Control Knob clockwise to dot marked RINSE & HOLD.

5.Close and latch the door to start the cycle.

2.With the Cycle Control Knob pulled out, turn clockwise to the cycle you want.

3.Be sure the detergent dispensers are filled properly for the new cycle.

4.Latch the door to start the cycle.

B