Rinse Aid Dispenser
Rinse aids keep water from forming droplets that can dry as spots or streaks. They also improve drying by allowing water to drain off of the dishes during the final rinse by releasing a small amount of the rinse aid into the rinse water. Your dishwasher is designed to use a liquid rinse aid. Do not use a solid or
Checking the dispenser
To check water temperature
1.Run hot water at the faucet closest to your dishwasher for at least 1 minute.
2.Place a candy or meat thermometer in a glass measuring cup.
Check the center of the fill indicator cap. Clear means it needs filling.
Or you can remove the fill indicator cap. If an “E” is visible, the dispenser is empty.
Filling the dispenser
The rinse aid dispenser holds 6 oz (175 mL) of rinse aid. Under normal conditions, this will last for about 3 months. You do not have to wait until the dispenser is empty to refill it. Try to keep it full, but be sure not to overfill it.
1.Make sure the dishwasher door is completely open.
2.Remove the fill indicator cap.
3.Add rinse aid. Fill to the smallest opening in the lower part of the dispenser. Overfilling can cause the rinse aid to leak out, and could cause oversudsing.
4.Clean up any spilled rinse aid with a damp cloth.
5.Replace the fill indicator cap. Close tightly.
Dishwasher Efficiency Tips
Hot water dissolves and activates the dishwashing detergent. Hot water also dissolves grease on dishes and helps glasses dry
3.Check the temperature on the thermometer as the water is running into the cup.
Additional efficiency tips
■To save water and energy and time, do not rinse dishes before putting them into the dishwasher.
■Use a low energy, quick, or short cycle whenever possible. These cycles use less hot water and energy than a normal cycle.
■Use a delay feature (on some models) to run your dishwasher during
■During the summer, run your dishwasher at night. This reduces daytime heat buildup in the kitchen.
■Use the
■Use cycles or options that add extra heat to the wash or rinse portion of the cycle only when needed.
■Run your dishwasher with full loads. Run a rinse cycle after meals until the dishwasher is full.
■If your home is equipped with a water softener, you may want to avoid starting the dishwasher during the regeneration of the softener, since this may contribute to poor wash performance.
Cycle Selection Charts
Turn the cycle control knob to the desired cycle. If the door is latched, you will hear the cycles start and stop as the cycle control knob passes each cycle mark. This is normal and does not hurt the dishwasher. If you prefer, you can set the cycle control knob with the door unlatched.
A“●” shows what steps are in each cycle. Water usage is shown in U.S. gallons/liters. Cycle time includes dry time.
9