To Removeovendoor NON-SELF-CLEANINGMODELS

TO REMOVEOVENDOOR (NON-SELF-CLEANINGMODELS)

Push down evenly.

Pull straight with the

angleof pa+opendoor.

Removing the oven door: (For installing and cleaning)

With the door off, you will notice how the ends of the hinges slide into slots at the bottom corners of the door. To put the door back on, fit both bottom corners of the door over the ends of the hinges. Push the door down evenly, so neither corner gets ahead of the other. When it reaches the bottom, you can close the door. A safety latch will hold the door open until it is on correctly.

4.CHECKING

CAUTION: Do not touch the elements. They may be hot and you may get burned.

A.THERMOSTAT

1.Broil - Turn selector switch to BROIL and set thermostat to a high temperature position. The top element should become cherry-red and the indicator light should glow.

2. Bake - Turn selector switch to BAKE and set * thermostat to 350”. The bottom element should become red and the indicator light should glow.

6.CLOCK

Refer to the Use and Care Guide for proper operation of the clock.

C.ROTISSERIE (if optional kit has been installed)

1.Position the spit bar on special rack.

2.Insert the point of spit bar into hole in the back of the oven.

3.Rotation starts upon insertion of spit bar.

Removing the oven door may make it easier to clean the oven. To remove the door, first open it to the first stop (about 4 inches or 10 cm). Take hold of both sides of the door near the top; then lift it at the same angle it is in.

the

event

your

WHIRLPOOL

appliance

should

need

serwce,

call

the

dealer

from

whom

you

purchased

the

appliance

a WHIRLPOOL

franchised

TECHCARE@

sewce

company.

is in

the

Yellow

Pages

of your

telephone