Contents |
| Page |
|
|
|
| Page | ||
BEFOREYOUPLUGiTiN.. | ............ | 3 | Cleaning | Exterior Surfaces | 6 | ||||
USING YOUR ICE MAKER | ............ | 4 | Cleaning | the | Condenser | 6 | |||
HowtheiceMakerWorks | ......... | 4 | Cleaning | the | Ice Maker System. | 7 | |||
Setting the Controls | 4 | Cleaning | the | Interior | Components | 8 | |||
Changing | the | Bin Door | Panel | 5 | Filtering and | Treating | Water | 9 | |
Changing | the | Light Bulb | 5 | VACATION | AND MOVINGCARE.. | 9 | |||
CLEANING | AND | CARING | FOR YOUR |
| IF YOU NEED SERVICE OR ASSISTANCE | 10 | |||
ICE MAKER | ......................... |
| 6 | WHIRLPOOL | ICE MAKER | WARRANTY | 12 | ||
cl987 Whirlpool Corporation
Before you plug it in
IMPORTANT
Before using your ice maker, you are personally responsible for making sure that it..
l has been installed where it is protected from the elements.
l is located so that the front is not blocked to restrict incoming or discharge air flow.
l is properly leveled.
l is located in a well ventilated area with temperatures above 55°F (13°C) and below 110°F(43°C). Best results are obtained
at temperatures between 70°F (21°C) and 90°F (32°C).
NOTE: A drain pump kit (Model EKDPI) is available a floor drain is inaccessible.
l is properly connected to a water supply and drain.
l is properly connected to electricity. A 115 Volt, 60 Hz., 15 amp fused electrical supply is required. NOTE: Time delay fuse or circuit breaker is recommended.
l is properly electrically grounded.
l is not operated by anyone unable to use it properly.
l is used only for the job it was designed to perform.
l is properly maintained.
as an option for installation where