| Improper connection of the equipment earthing conductor can result in the risk of an electric shock. |
WARNING! | Check with a qualified electrician or service representative if you are in doubt whether the |
appliance is properly earthed. | |
| Do not modify the plug provided with the appliance. If the plug does not fit properly to the outlet, |
| please have a qualified electrician to install a proper outlet. |
Water Connection
| Connect the cold water supply hose to a threaded 3/4(inch) connector and make sure |
| that it is fastened tightly in place. |
| If the water pipes are new or have not been used for an extended period of time, let the |
| water run to make sure that the water is clear. This precaution is needed to avoid the |
| risk of the water inlet to be blocked and damage the appliance. |
| The water supply to the appliance can also be connected to the household hot water |
| line (such as, central system, heating system),as long as it does not exceed a |
| temperature of 60 C. In this case, the wash cycle time will be shortened by about 15 |
| minutes and the wash efficiency slightly reduced. |
| The connection must be made to the hot water line following the same procedures as |
| described in the section for the connection to the cold water line. |
WARNING! | In order to avoid that there is more water staying in the inlet hose, please close |
the hydrant after using.(Not applicable to appliances without |
Positioning the Appliance
Position the appliance in the desired location. The back should rest against the wall behind it, and the sides, along the adjacent cabinets or walls. The dishwasher is equipped with water supply and drain hoses that can be positioned either to the right or the left sides to facilitate proper installation.
How to Drain Excess Water From Hoses
If the sink is 1000 higher from the floor, the excess water in hoses cannot be drained directly into the sink. It will be necessary to drain excess water from hoses into a bowl or suitable container that is held outside and lower than the sink.
Water Outlet
Connect the water drain hose. The drain hose must be correctly fitted to avoid water leaks.
Ensure that the water inlet hose is not kinked or squashed.
Extension Hose
If you need a drain hose extension, make sure to use a similar drain hose.
It must be no longer than 4 metres; otherwise the cleaning effect of the dishwasher could be reduced.
Syphon Connection
The waste connection must be at a height of between 50 cm (minimum) and 100 cm (maximum) from the bottom of the dish. The water drain hose should be fixed by a hose clip.
Start of Dishwasher
The following things should be checked before starting the dishwasher.
1The dishwasher is level and fixed properly
2The inlet valve is open
3There is a leakage at the connections of the conducts
4The wires are tightly connected
5The power is switched on
6The inlet and drain hoses are knotted
7All packing materials and printings should be taken out from the dishwasher
After installation, please make sure to keep this manual.
The content of this manual is very helpful to the users.
22