Whirlpool ADG 195 A+ manual Before Calling for Service, Technical problems General problems Noise

Page 26
Before Calling for Service

Before Calling for Service

Technical problems

General problems

Noise

Fuse blown, or the

Replace fuse or reset circuit breaker. Remove any other

circuit breaker acted

appliances sharing the same circuit with the dishwasher

 

Power supply is not

Make sure the dishwasher is turned on and the door is

turned on

closed securely.

 

Make sure the power cord is properly plugged into the

 

wall socket.

 

 

 

Error code:E1;

Check that the water supply is connected properly and

Water pressure is low

the water is turned on.

 

Door of dishwasher

Make sure to close the door properly and latch it.

not properly closed.

 

 

Kink in drain hose

Check drain hose.

 

 

 

Filter clogged

Check coarse the filter

 

(see section titled " Cleaning The Filter ")

 

 

 

Kitchen sink clogged

Check the kitchen sink to make sure it is draining well.

 

If the problem is the kitchen sink not draining ,you may

 

need a plumber rather than a serviceman for dishwashers.

Improper detergent

Use only the special dishwasher detergent to avoid

 

suds. If this occurs, open the dishwasher and let suds

 

evaporate. Add 1 gallon of cold water to the tub. Close

 

and latch the dishwasher, then Start the "soak" wash

 

cycle to drain out the water . Repeat if necessary.

 

Spilled rinse-aid

Always wipe up rinse-aid spills immediately.

Detergent with

Make sure that the detergent is the one without

colourant was used

colourant.

Hard water minerals

To clean the interior, use a damp sponge with

 

dishwasher detergent and wear rubber gloves.

 

Never use any other cleaner than dishwasher

 

detergent for the risk of foaming or suds.

The affected items are

 

 

not corrosion resistant.

 

 

A programme was not

Always run the quick wash programme .

run after dishwasher

without any crockery in the dishwasher and

salt was added.

without selecting the Turbo function (if present),

Traces of salt have

after adding dishwasher salt.

gotten into the wash cycle.

 

 

 

The lid of the softer

Check the lip .Ensure the fix is fine.

is loose

 

 

A spray arm is

Interrupt the programme, and rearrange the items

knocking against

which are obstructing the spray arm.

an item in a basket

 

 

Items of crockery

Interrupt the programme,

are loose in the

and rearrange the items of crockery.

wash cabinet

 

 

This may be caused

This has no influence on the dishwasher function.

by on-site installation

if in doubt, contact a suitably qualified plumber.

or the cross-section of

 

 

the piping.

 

 

23

Image 26
Contents 技术要求: 1. 所有内容的印刷颜色均为PANTONE Black C2.规格为:A4 3.如供应商的排版需要加空白页,请加在后面ADG 195 A+ Dear Customer When using your dishwasher, follow the precautions listed below polyoxymethylene, e.g. plastic clips for polyethylene, e.g. sheet wrapping materialfor polystyrene, e.g. padding material polypropylene, e.g. Salt filler2 Program Key-pressTo select washing program when press the Key-press Note1 Adjusting Salt ConsumptionA. Water Softener Note2Rinse Aid Dispenser B. Loading the Salt Into the SoftenerC. Fill the Rinse Aid Dispenser Function of Rinse AidD. Function of Detergent When to Refill the Rinse Aid DispenserAdjusting Rinse Aid Dispenser DetergentsDetergent Dispenser Concentrated DetergentDetergent Tablets Amount of Detergent to UseHow To Use The 3IN1 Function Fill in DetergentLoading the Upper Rack Adjusting the Upper BasketAttention before or after Loading the Dishwasher Baskets 5. Oval platter 6. Saucer Loading the Lower Basket1. Cutlery basket 2. Dessert plates 3. Soup plates 4. Dinner plates Are of limited suitability Cutlery BasketAre not suitable Tea spoonsWash Cycle Table IntensiveForgot to Add a Dish? Turning On the ApplianceChange the Program At the End of the Wash CycleMain filter Filter assemblyFiltering System Coarse filterCleaning the Spray Arms Cleaning the FilterCleaning The Door RemarksInstallation preparation 【Figure2】 Aesthetic panels dimensions and installation【Figure1】 【Figure3】【Figure4a】 【Figure4b】【Figure5】 Tension adjustment of the door springConnection of drain hoses 【Figure6 】Dishwasher installation steps 【Figure 7】【Figure 8 】 How to Drain Excess Water From Hoses Water ConnectionStart of Dishwasher After installation, please make sure to keep this manualBefore Calling for Service Technical problems General problems NoiseError Codes Unsatis -factory washing result Unsatis -factory drying result9 Place settings 820mmadjustable+60mmPower supply Height