Before using your dishwasher for the first time:
A. Set the water softener
B. Pour 1／2 litre of water inside the salt container and then fill with dishwasher salt C. Fill the rinse aid dispenser
D. Fill in detergent
A. Water Softener
The water softener must be set manually, using the water hardness dial.
The water softener is designed to remove minerals and salts from the water, which would have a detrimental or adverse effect on the operation of the appliance. The higher the
content of these minerals and salts, the harder your water is. The softener should be adjusted according to the hardness of the water in your area. Your local Water Authority can advise you on the hardness of the water in your area.
Adjusting Salt Consumption
The dishwasher is designed to allow for adjustment in the amount of salt consumed based on the hardness of the water used. This is intended to optimise and customise the level o f salt consumption.
Please follow the steps below for adjustment in salt consumption.
1. Unscrew the cap from the salt container.
2. There is a ring on the container with an arrow on it (see figure on the side), if necessary, rotate the ring in the anticlockwise direction from the
It is recommended that adjustments should be made in accordance with the following scheme:
| WATER HARDNESS |
|
| Salt consumption | Auto nomy | ||
|
|
|
| Selector Position | |||
dH | fH | Clarke | mmol/l | (gram/cycle) | (cycles/1kgs) | ||
| |||||||
|
|
| |||||
0~8 | 0~14 | 0~10 | 0~1.4 | / | 0 | / | |
8~22 | 14~39 | 10~28 | 1.4~3.9 | - | 20 | 50 | |
22~45 | 39~80 | 28~56 | 3.9~8 | Mid | 40 | 25 | |
45~60 | 80~107 | 56~75 | 8~11 | + | 60 | 16 | |
Note:1 ° | ° | ° | Note:2 | ||
dH=1.25 Clarke=1.78 | fH=0.178mmol/l | "/" | No salt need added | ||
|
|
| |||
°DH: | German degree |
|
| Setting toward | |
° fH: | French degree |
| "+" | Setting toward the"+" sign | |
|
|
| Setting toward between | ||
° Clark: British degree | "Mid" | the |
| ||
|
|
Contact your local water board for information on the hardness of your water supply.
4