CommonDishwashingProblems
Spotting and filming Hard water
FINdetergent dispensers to capacity. Use dishwasher detergent with highest available phosphorus content. May be necessary to install water softener.
To remove spots and film, try a vinegar rinse...
1.Wash and rinse load as usual. Use Arr Dry Option.
2.Remove all metal items.
3.Put 2 cups (500 mL) white vrnegar in a container on the bottom rack.
4.Run dishwasher through a complete washing cycle.
Water is not hot enough
Water temperature should be at least 140°F (SOC). Set water heater thermostat to a higher setting. Run water at sink until hot before starting
Not enough detergent, or improper detergent
Use more dishwasher detergent. Use detergent with highest available phosphorus con- tent...especially with hard water.
“Old” detergent
Use only fresh dishwasher detergent. Store tightly closed container, in cool, dry place Discard old detergent. Do not fill dispensers until ready to start dishwasher.
Improper loading
Make sure dishes and glassware are loaded so spray reaches all surfaces and items dram properly. Do not overload. Do not nest items.
Make sure large items do not block spray from reaching detergent dispensers.
No rinse agent
Does the rinse agent dispenser need filling? See Instructions on page 10.
AIR DRY Setting used
Drying without heat may result in some spotting of glasses and silver.
Small particles deposited on items Spray arm not rotating freely
Check spray arm to make sure it turns freely after loading. Be sure a utensil has not prevented its turning.
“Old” detergent
Use only fresh dishwasher detergent. Store tightly closed container, in cool, dry place. Discard old detergent. Do not fill dispensers until ready to start dishwasher.
Not enough detergent, or improper detergent
Use more dishwasher detergent. Use detergent with highest available phosphorus content.. especially with hard water.
Water is not hot enough
Water temperature should be at least 140°F (60°C). Set water heater thermostat to a higher setting. Run water at sink until hot before starting
Water pressure may be low, dishwasher is not filling properly
If water pressure is low, do not use water for other purposes while dishwasher is running (to assure correct fills).
Dishes not dry
No rinse agent
Does the rinse agent dispenser need filling? See instructions on page 10.
Water is not hot enough
Water temperature should be at least 140°F (SOOC).Set water heater thermostat to a higher setting. Run water at sink until hot before starting.
Improper loading
Make sure dishes and glassware are loaded so spray reaches all surfaces and items drain properly. Do not overload. Do not nest items.
AIR DRY Setting used
Allow more time when using Air Dry Option, or use Heat Dry Option. Plastic items may need towel drying.
Black marks on dishes
Aluminum utensils rubbing against items during washing
Use care in loading aluminum utensils,
especially any lightweight foil container. Place so they do not touch dishes. Remove black marks with plastic scouring pad and a mild abrasive cleanser.
Chipping or breaking gfassware
Improper loading
DO not overload. Load glasses in the top rack only. Load between prongs, not over them. Glasses loaded over prongs will not be supported and may chip or break.
13