Operating Instructions Continued
8400 Series Models
Startingyourdishwasher
1.Select a drying option. (See page 6.) The indicator above the button will show red when that option has been selected.
NOTE: Select AIR DRY for the Rinse 8 Hold Cycle.
For the 8300 series models, the Heat Dry Option is automatically selected with the Pots & Pans Cycle.
2.For the 8300 series models, if the Pots 8 Pans Cycle will be used, push the POTS & PANS button. The indicator above the button will show red.
For the 8400 series models, push a Cycle Selector button for the desired cycle. Normal Wash, Light Wash and Rinse & Hold Cycles share the same button. The Cycle Control Knob determines which cycle operates.
3.Turn the Cycle Control Knob clockwise to point to a desired cycle. You will feel a definite stop at each cycle mark. The dishwasher will automati- cally start the cycle you selected.
NOTE: If the door is latched, you will hear cycles start and stop as the knob passes each cycle mark. This is normal and will not hurt the dish- washer. If you prefer, you can set cycles with the door unlatched.
Cycle control knob
Toadda dishafterstarting
1.To be sure that added item is washed and rinsed, make sure the Cycle Control Knob has not passed LIGHT WASH.
2.Lift up on the door latch to unlatch door and stop the cycle. Don’t open the door until the spray arms stop spinning.
3.Open the door and add the dish.
4.Close the door. Do not latch it. Wait 30 seconds for air in the dishwasher to warm up. This helps reduce the amount of moisture that can come from the vent when restarting the cycle.
5.Press door in to latch it. This dishwasher will start where it stopped.
Changing cyclesetting
You can change a setting anytime during any cycle.
1.Lift up on the door latch to unlatch the door and stop the cycle.
2.Turn the Cycle Control Knob clockwise to the cycle you want.
3.Be sure the detergent dispensers are filled properly for the new cycle. When changing dial from LIGHT WASH to NORMAL WASH or POTS & PANS setting, detergent is released. Reload covered section of dispenser before starting Normal Wash Cycle or Pots & Pans Cycle.
4.Close and latch the door. The dishwasher will automatically start the new cycle.