Now start, With dishwasher in kitchen | Whirlpool 3369088 specs

Water requirements

The hot water line to the dishwasher must provide between 15 - 120 PSI water pressure. The hot waler healer should be set lo deliver 140°F waler temperature to the dishwasher for besl resulls.

Use 310” O.D. copper tubing or l/2” plastic tubing minimum inlet line. Dishwasher inlet valve has 3/S internal pipe thread.

Drain requfrements

Drain line connection to house plumbing must be minimum 20” above floor to prevent siphoning.

Draln hose, supplied, meets AHAM DW-1 test standards. Cut

l-112’ hole in cabinet wall for drain hose. Additional drain Ilne, a minimum of l/2’ I.D. and no longer than 20 feet can be used if needed.

Numbers correspond to steps.

Now start ...

with dishwasher in kitchen.

Disconnect electric supply before insialling dishwasher.

1 Remove the 4 screws

n ottoching access panel and toe panel to dishwasher using a 114” socket wrench or Phlllrps screwdriver Remove access panel and toe ponel.

The dishwasher ISshipped to

. be rnstalled In a 34” cabinet opening. Meosure height of coblnet opening from underside of countertop to floor. Check chart for that heiaht openno. Put the wheels in the re-quireb posiion

For addllional helghl.

I Add shims under Ihe wheels

2.Turn fronl levelem leach I”,” adds I,16 in heighll.

Loosen and then turn front levelers the number of times indicated in the chart

Panel B