Whirlpool 3369088 installation instructions

Page 4

WI dishwasher backwards on

-

3 Place draln hose in the n center of the cabinet

opening. Latch dishwasher door. Push dishwasher into place. Center dishwasher in cabinet opening. Check that front leveling legs

are firmly against the floor. Align dishwasher door wtih cabinet doors so that spacing is the same on both sides.

4 Use pliers to open clamp and

. place over water Inlet hose. Connect water Inlet hose to water vatve. Slide clamp over Inlet hose and water valve. Check for good fB Turn on water supply and check for leaks.

5 Loosen drain hose clamp

. screw. Place clamp over drain hose. Connect drain hose to check valve. Tighten draln hose clamp screw. Check for good fit Coil and taae extra drain hose under kitchin sink.

Panel C

Open dishwasher

H ond remove all shipping materials. Remove bottom rack. Place a newspaper or large sheet of paper over bottom of dishwasher to brdtect the pump area when- - securing dishwasher to countertop.

7 Secure dishwasher to

n countertop with two No. 10 x l/2” Phillips head screws from parts bag. You MUST secure dishwasher to keep it from tilting when door is opened or closed. Da nOl drop screws in dishwasher tub. If screws should fall into fhe auma. pump and motor failure &y c&r. Remove paper from bottom of dishwasher.

equally spaced

Open door approximately 3’ and check for equal spacing between inner door and tub sides. If necessary. loosen screws that fasten dishwasher to countertop and shift tub. Tighten screws.

.\

9 Check door for proper

n operation. Door should close easily without slamming and open with its own weight. If necessary. close door and adjust door spnng by moving end of spring to a different hole in base.

10 Plug wiring horness to n water valve

11 Plug wiring harness to

. terminal box CHECK ELECTRICAL REQUIREMENTS. BE SURE YOU HAVE CORRECT ELECTRICAL SUPPLYAND RECOMMENDED GROUNDING METHOD.

12 Toke a few minutes to

. read the Use and Care Guide to fully understand Your new dishwasher.

13 Check thot all parts have

. been instolled and no steps were skipped. Check that you hove all the tools You started with.

14 Turn on electric supply, n Start dishwasher and

allow it to complete a cycle Check that dishwasher is working properly and that there are no water leaks.

15 Replace the access n panel and toe panel.

16 If color of door is to be

. chanaed or custom panel installed. Change the panel now. See back cover for detailed instructions

Image 4
Contents For future reference Installer Leave Installation InstructionsPart Parts supplied for installation Before you startTools needed for fnstallation Important Observe all governing codes and ordinancesNow start With dishwasher in kitchenPage To change door panel color