Audible signals
Audlble signals are available to guide you when setting and using your oven. (A programming tone will sound each time you touch a pad. Two beeps will sound between cycles. A reminder tone will sound every 30 seconds after cooking is done to remind you that something has been left in the oven. A
4 second tone signals the end of the Minute Timer function.) If you don’t hear a tone, it is because of lnCOmdiy entered instructions or because the tones have been removed. For example, a tone will not sound if you touch a Number Pad before you touch a Command Pad.
To remove | the | programming tone: | To remove | all tones: | ||||
l | Open | the | door. | l Open | the door. | |||
l Touch CANCELtwice, touch 0, then touch START. | ||||||||
l Touch CANCEL twice, then touch START. | ||||||||
l All audible tones (including minute timer sig- | ||||||||
| Programmlng | and reminder tones will be | ||||||
l | nal) will | be cancelled. | ||||||
| cancelled. |
|
| NOTE: Do not remove ail tones if YOU use the | ||||
|
|
|
|
| ||||
To replace | the | tones: | Minute | Timer. | ||||
l | Repeat the steps above. | To replace | the tones: | |||||
|
|
|
|
| l Repeat the steps above. | |||
NOTE: if your eiectrlcity goes off, the audible signals will come back on. Repeat steps above if you want to remove them again.
Setting the clock
When the oven is first plugged in, the Clock/Display shows 88:88. If the electric power ever goes off, the Clock/Display will again show all 8’s when the power comes bock on.
You can cook or use the Minute Timer without setting the clock, but the display will be blank after cooking.
DO THIS... | THIS HAPPENS... |
The Display will show a “0”and the colon will start to flash. The first Number Pad must be touched withln 5 seconds or the Display will go blank. Touch CLOCK SETagain and continue.
2. Touch Number Pads for the correct ttme of day.
The Display will show what numbers you touched in the order you touched them. This example shows 3:25.
The colon will stop flashing. The Clock ISset.
If you have touched in an incorrect time, such as1265 “Err”will show on the Display. Touch CLOCK SETand start over.
NOTE: To reset the clock, touch CLOCK SET.The current ttme will show on the Display and the colon will flash. Continue to set the clock as shown above.
6