Display
When power is first supplied to the microwave oven, “0:00” will appear in the display. If the “0:00” appears in the display at any other time, a power failure has occurred. Reset the clock if needed. See “Clock.”
When the microwave oven is in use, the display will show cook time remaining. When the microwave oven is not in use, the display will show the time of day (if the clock is set) or Timer countdown (if the Timer is set).
Start
The START control begins any function. If cooking is interrupted by opening the door, touching START will resume the cycle.
NOTE: To avoid unintentional operation of the microwave oven, a cooking function cannot be started if the microwave oven door has been closed for about 5 minutes. The word “door” will appear in the display until the door is opened and closed.
Add 30 Seconds
The ADD 30 SEC control (START pad) automatically starts the microwave oven at 100% power for 30 seconds, and adds 30 seconds of cook time with each additional touch of the control.
Time may be added to any manual cooking cycle in
NOTE: To avoid unintentional operation of the microwave oven, a cooking function cannot be started if the microwave oven door has been closed for about 5 minutes. The word “door” will appear in the display until the door is opened and closed.
Cancel
The CANCEL control clears any incorrect command, and cancels any program during cooking. It will not erase the time of day.
The microwave oven will also turn off when the door is opened. Close the door and touch START to resume the cycle.
The CANCEL control is also used to lock and unlock the control panel. See “Control Lock.”
Clock
This is a standard
To Set:
The microwave oven and Timer must be off.
1.Touch CLOCK.
2.Touch number pads to enter correct time of day.
3.Touch CLOCK.
Timer
The Timer can be set in minutes and seconds, up to 99 minutes 99 seconds, and counts down the set time.
NOTE: The Timer does not start or stop the microwave oven.
Cook functions may be used while the Timer is counting down. When the cook function is active in the display, touch TIMER to see the Timer count down for about 5 seconds.
To Set:
1.Touch TIMER.
2.Touch number pads to enter desired time.
3.Touch START.
When the set time ends, “End” will appear in the display and the
4.Touch CANCEL while the Timer is active in the display to cancel the Timer.
Control Lock
The Control Lock disables the control panel pads to avoid unintended use of the microwave oven.
To Lock/Unlock Control: The microwave oven must be off. Touch and hold CANCEL for about 3 seconds, until the tone sounds and the control lock icon appears in the display. Repeat to unlock.
If any control pad is touched while the control is locked, there will be no response from the control.
Tones
Tones are audible signals that cannot be turned off, and they indicate the following:
One tone
■Valid entry
■Control lock activated or deactivated
■End of stage in multistage cooking
Three tones
■End of Timer countdown
Five tones
■End of cycle
■Reminder, repeat each minute after the
Language
The default display language is English, but may be set to French. Two display messages are affected: “End” (English) or “Fin” (French), and “door” (English) or “PrtE” (“porte” - French).
To Set Language to French: With the microwave oven door open, touch and hold number pad 1 for about 5 seconds, until a tone sounds. Repeat to change back to English.
Weight Entry Mode
The default weight entry mode for Weight Defrost is imperial (pounds), but may be set to metric (grams). This setting does not affect any other program besides Weight Defrost. See “Weight Defrost/Timed Defrost” section.
To Set Weight Entry to Metric: With the microwave oven door open, touch and hold number pad 0 for about 5 seconds, until a tone sounds. Repeat to change back to imperial.
7