Whirlpool Ni-l30 manual Install the Mounting Plate, Step Setup position

Page 10

A-2. Install the Mounting Plate

Step. 1 Setup position

a. Draw a line down the middle of the studs(See the Wall Consa_ction, page 5)

b. Draw a vertical line on the wall at the center of the 30" wide space.

NOTE: Use the wall template for the rear wall.

Reference Wall Template prior to proceeding.

Installation of this product require TWO persons.

Step. 2 Drilling

Reference the Wall Template.

Step. 3 Install the damper

Fit the damper into the house duc_ Be sure that the damper hinge is on the top and the dotnper free into the wall outlet.

Takethe28"foam

tapesandremove thepaperfrom stickysidePress. thestickysideonto

the front edge of the

damper. (Don't stretch the foam

tape)

Plate

Step. 4 Tightening the screws

ToAttach the mounting plate to the wall using the toggle bolt assemblies and/or lag screws:

Image 10

Contents Installatin Guide Important Safety Information IntroductionSafety Instructions Installation Hardware Arts L is tNi-l Mounting SpaceWall Construction Hood Exhaust Duct Ventilation system Instructions Horizontal Ventilation SystemStep.3 Install the Mounting Plate Step Setup positionThroughthewalstudsl Mounting microwave oven Preparationof TOP CabinetSecured with TWO Mounting Bolts Ov entop Vertical Ventilation System Recirculation Ventilation System Checklist for Installation Warni O CEI LL TEM PLA. ---- E ,,,t Ormorefrom the floor Drilla Lnsert Minimum of one 1 la 1lag screwinto a wall stud Over Drilla 3,16dia.hole Fillerblock Cabinf IET T MPL ATE E Cutout 2 50.8ramdiametholerMetalcabinet Drilled Jctions trical 1injury Page Top cobihet On edgeofholeto prXect Cobihet Onedgeofholetoprotect 19 .! rn Powercordfromdamage