INSTALLATION
PRIOR TO CONNECTING
CHECK THAT THE VOLTAGE on the rating
plate corresponds to the voltage in your home.
DO NOT REMOVE THE MICROWAVE INLET PROTECTION
PLATES located on the side of the oven cavity wall. They prevent grease & food parti- cles from entering the mi- crowave inlet channels.
PLACE THE OVEN ON A STABLE, EVEN SUR-
FACE that is strong enough to hold the oven and the food uten-
sils you put in it. Use care when handling.
THIS OVEN IS NOT INTENDED to be placed or
used on a working surface lower than 850 mm above the floor.
ENSURE THAT THE APPLIANCE IS SWITCHED OFF
before replacing the lamp to avoid the possibility of electric shock.
AFTER CONNECTING
WHEN THE APPLIANCE is first plugged in or after a power failure, the display is blank. If required, the oven can display a
When the Clock function is not programmed the display will remain blank until the cooking time or the Timer is set.
THE OVEN CAN BE OPERATED ONLY if the oven door is
firmly closed.
POOR TELEVISION RECEPTION
POSITION THE OVEN AT A DISTANCE from other heat-
ing sources. For sufficient ventilation there must be a space of at least 20 cm above the oven. Ensure that the space underneath, above and around the oven is empty to allow for proper airflow. The microwave oven shall not be placed in a cabinet.
ENSURE THAT THE APPLIANCE IS NOT DAMAGED. Check
that the oven door closes firmly against the door support and that the internal door seal is not damaged. Empty the oven and clean the interior with a soft, damp cloth.
DO NOT OPERATE THIS APPLIANCE if it has a
damaged mains cord or plug, if it is not working properly, or if it has been dam- aged or dropped. Do not immerse the mains cord or plug in water. Keep the cord away from hot surfaces. Electrical shock, fire or other hazards may result.
THE EARTHING OF THIS APPLIANCE is compulso-
ry. The manufacturer will accept no re- sponsibility for injury to persons, ani- mals or damage to objects arising from the
and radio interference may result if the oven is located close to a TV, radio or aerial.
The manufacturers are not liable for any problems caused by the user’s failure to ob- serve these instructions.
2 | GB |