Whirlpool EHl50FX, EHI00FX, EH070FX, EH050FX manual Using Your Freezer Contlnued Signal light EH220FX

Using Your Freezer

Contlnued

The signal light (EH220FX)

The signal light automatically warns of any unexpected power failure.

If the signal light is not glowing, immediately check:

l

l

l

l

for power interruption.

for an unplugged power cord.

for an open circuit breaker or blown fuse. for a burned out signal light.

The drain cover

To remove drain cover for defrosting:

1.Remove drain cover by pulling out.

2.Insert hose adapter provided into drain outlet.

3.Remove rubber stopper from inside bottom of freezer.

4.Place a pan under the drain, or attach a hose to the threaded end of the adapter and direct water into a separate drain.

To replace drain cover after defrosting:

1.Remove hose adapter.

2.Replace rubber stopper.

3.Replace drain cover.

Changing the light bulbs (EH220FX)

Elect&al Shock Hazard

Before removing a light bulb, either unplug the freezer or disconnect the electricity leading to the freezer at the main power supply. Shock and Injury can occur If elec- tricity remains connected.

To change the interior light:

1.Disconnect freezer from power supply.

2.Reach behind light lens to remove bulb.

3.Replace bulb with a 15-watt appliance bulb.

4.Reconnect freezer to power supply.

To change the signal light:

1.Disconnect freezer from power supply.

2.Carefully snap out light cover and assembly with a screwdriver by inserting it under the metal edge of light. Be careful not to chip finish on freezer handle.

3.Unplug burned out signal light and replace with a new one. Signal light can be ordered from your authorized Whirlpool servicer.

4.Snap light cover and assembly into place.

5.Reconnect freezer to power supply.

6