Install properly... | Remove | sales labels... | |
| Remove the Consumer Buy Guide label and any | ||
| lnslde labels before using the freezer | ||
| To remove any remalnlng glue: | ||
| 1. Rub briskly with thumb to make a ball, then | ||
| remove |
|
|
| OR |
|
|
| 2. Soak area with dishwashing detergent solution (1 | ||
| teaspoon | detergent | in 1 quart warm water] be- |
| fore removing glue as described in step 1 | ||
| DO NOT USErubbing alcohol or flammable or | ||
| toxic solvents, such as acetone, gasoline, car- | ||
| bon tetrachloride, | etc. These can damage the | |
| material. |
|
|
| NOTE: DO NOT REMOVE the Tech Sheet fas- | ||
| tened under the freezer at the front. | ||
I, Check the strength of the floor. It should hold the weight of a fully loaded freezer
2.Pick a safe place, indoors, away from in- flammables such as gasoline.
3 Allow 3 inches (7 5 cm] arr space on top of freezer for proper ventrlation.
4.Allow at least an inch (2.5 cm) between the freezer condenser, on the back of the unit, and the wall
5Allow % inch (1 25 cm) on each srde of the freezer for ease of installation.
6.If the freezer is to be against a wall, you mrght want to leave extra space on the hinge side so the door can be opened wider.
Level freezer...
so the door will stay open at any position.
Raiselower
Start ad)ustment with the door hinge side.
I, Slide the freezer into place.
2.Adjust front legs to level the freezer.
3.Check with level.
4.After freezer is fully loaded, recheck with level
Clean it ...
Clean your freezer befor using it. See cleaning tnstructions on page 6.
Plug it in...
Retaining Clip
Freezer 1
Power Plug I
Recommended Grounding Method
A 115 Volt, 60 Hz., AC only 15 or 20 ampere fused and properly grounded electrical supply is required. It is recommended that a separate circuit serving only
this appliance be provided. Use a receptacle which cannot be turned off with a switch or pull chain. Do not use an extenslon cord.
Attach retaining clip over power cord plug from literature package inside the freezer.