Tnstall properly, Clean it, Plug it | Whirlpool EVISOE guide

tnstall properly...	Remove		sales labels...
	Remove the Consumer Buy Guide label and any
	inside labels before using the freezer.
	To remove		any	remaining		glue:
	1 Rub briskly with thumb to make a ball, then
	remove
	OR
	2 Soak area wrth drshwashrng detergent solutron (I
	teaspoon		detergent		in	1 quart	warm water]		be-
	fore removrng glue as described In step 1.
	DO	NOT USE rubbing alcohol					or	flammable	or
	toxic	solvents,		such	as	acetone,		gasoline,	car-
	bon tetrachloride,				etc.	These	can	damage	the
	material.
	NOTE: DO NOT REMOVE the Tech Sheet fas-
	tened	under	the freezer			at the	front.

Check the strength of the floor It should hold the weight of a ful!y loaded freezer

Pick a safe place, indoors, away from in-

flammables such as gasoline.

Allow 3 inches (7 5 cm] arr space on top of freezer for proper ven+Uat~on

Allow at leas’ an inch (2 5 cm) between the freezer conde.:ser. on ?he back of the unit, and the wall

Allow “,inch [I 25 cm] on each srde of the freezer for ease of rnstallatroc

If the freezer 1s to be agarnst a wall, you might want to leave extra space on the hinge side so the door can be ooened wrder

The four bolts ti-at held your freezer or the shrpping crate are deslgned to be the levellrng legs Screw the legs far enough Into the bolt holes, In each of the four bottom corners, so the freezer stands about 1 lrxh (2 5 cm] off the floor

Clean it ...

Clean your freezer before using It See cleaning rnstructrons on page 6

Plug it in...

3-prong grounding type wall receptacle

Level freezer...

so the door wit stay open at any postIon

Levelling Leg

tower Raise

Start adjustment with the door hinge side.

1.Slide freezer into place.

2.Adjust front legs to level the freezer.

-To raise front, turn each leg in the direction shown.

-To lower front, turn each leg in the direction shown.

3.Check with level.

4.After freezer is fully loaded, recheck with level.

Freezer

Power Cord

yluullulng plug

Recommended Grounding Method

A 115 Volt, 60 Hz.. AC only 15 or 20 ampere fused and properly grounded electrrcal supply IS re-

quired It IS recommended that a separate crrcurt serving only thus applrance be provtded

Do not use an extension cord. Use a recep- tacle which cannot be turned off with a switch or pull chain. See indrvrdual electrical require- ments and groundrng instruction sheet in your liter- ature package