Whirlpool AKZM 755 Maintenance, Cleaning cycle of ovens with pyrolysis function if present

Cleaning the rear wall and catalytic side panels of the oven (if present):

IMPORTANT: do not use corrosive or abrasive detergents, coarse brushes, pot scourers or oven sprays which could damage the catalytic surface and ruin its self-cleaning properties.

•Operate the oven empty with the fan-assisted function at 200°C for about one hour

•Next, leave the appliance to cool down before removing any food residue with a sponge.

Cleaning cycle of ovens with pyrolysis function (if present):

WARNING	- Do not touch the oven during the pyrolysis cycle.
	- Keep children away from the oven during the pyrolysis cycle.

This function burns off spatters produced inside the oven during cooking at a temperature of approx. 500°C. At this high temperature, the deposits turn into a light ash which can be easily wiped away with a damp cloth, when the oven is cool. Do not select the pyrolysis function after every use, only when the oven is very dirty or produces smoke or fumes while preheating or cooking.

•If the oven is installed below a hob, make sure that all burners or electric hotplates are switched off during the self-cleaning (pyrolysis) function.

•Remove all accessories before running the pyrolysis function.

•For optimum cleaning of the oven door, remove the worst soiling with a damp sponge before using the pyrolytic function.

The appliance is equipped with 2 pyrolysis functions:

1.Energy-saving cycle (PYRO EXPRESS/ECO): which consumes approximately 25% less energy than the standard cycle. Select it at regular intervals (after cooking meat on 2 or 3 consecutive occasions).

2.Standard cycle (PYRO): which is suitable for cleaning a very dirty oven.

•In any case, after a certain number of uses and depending on how dirty the oven is, a message on the

oven display advises you to run a self-cleaning cycle.

N.B.: during the pyrolysis function, the oven door will not open; it will remain locked until the temperature inside the oven has returned to an acceptably safe level.

MAINTENANCE

WARNING	- Use protective gloves.
	- Ensure the oven is cold before carrying out the following operations.
	- Disconnect the appliance from the power supply.

REMOVING THE DOOR

To remove the door:

1.Open the door fully.

2.Lift the catches and push them forwards as far as they will go (Fig. 1).

3.Close the door as far as it will go (A), lift it up (B) and turn it (C) until it is released (D) (Fig. 2).

To refit the door:

1.Insert the hinges in their seats.

2.Open the door fully.

3.Lower the two catches.

4.Close the door.

Fig. 1 Fig. 2

EN6