Whirlpool 8523782 installation instructions Gas conversions, If flame needs to be adjusted

ECheck operation

(cont.)

If your oven has this type of electronic control pads (with and without timer):

CLOSE DOOR ON

BAKE

BROIL

PREHEAT

CLEAN

START ? 888

DOOR LOCKED

BAKE	CUSTOM	AUTO	TEMP	START	OFF
	BROIL	CLEAN		ENTER	CANCEL
				5 SEC

A

TIMERON

BAKE

BROIL

START ? 888

HEAT

CLEAN

DOOR LOCKED

	CUSTOM	AUTO	TEMP/	CLOCK	START	OFF
BAKE				TEMP
	BROIL	CLEAN	TIME	TIMER	ENTER	CANCEL
					5 SEC

B

1.Press the “CUSTOM BROIL” pad.

•“525” or “HI” will appear in the display.

•The “BROIL” indicator will light.

2.Press the “START/ENTER” pad.

•“HEAT”(console B only) and “ON” indicators will light.

•If the burner fails to light due to air remaining in the gas line, reset the oven control by pressing the “OFF/CANCEL” pad and then pressing the “CUSTOM BROIL” and “START/ENTER” pads again to reactivate the bake operation.

If your oven has this type of electronic control pads:

			888°F	ON	88:88
			HEAT BAKE BROIL			CLEAN	TIMER
						TIMER				START	OFF
BAKE	CUSTOM	AUTO	TEMP		CLOCK	SET	LIGHT	HR	MIN
						TIMER				ENTER	CANCEL
	BROIL	CLEAN
						OFF				5 SEC
C
			HEAT BAKE	88:88TIMER STOP				SET	OFF
			C					TIMER	TIMER	CLOCK	LIGHT
			888F	ON
			DELAY BROIL		LOCKED	CLEAN
			TIMED	START?	COOK	TIME
	CUSTOM	AUTO	TEMP		COOK	DELAY	STOP			START	OFF
BAKE						START		HR	MIN
	BROIL	CLEAN			TIME		TIME			ENTER	CANCEL
						TIME
										5 SEC

D

1.Press the “CUSTOM BROIL” pad.

•“HI” will appear in the display.

•The “BROIL” indicator will light.

2.Press the “START/ENTER” pad.

•“HEAT”and “ON” indicators will light.

•If the burner fails to light due to air remaining in the gas line, reset the oven control by pressing the “OFF/CANCEL” pad and then pressing the “CUSTOM BROIL” and “START/ENTER” pads again to reactivate the bake operation.

23.Check the broil burner for proper flame. The flame should be 1/2" long, with inner cone of bluish-green, and outer mantle of dark blue, and should be clean and soft in character. No yellow tips, blowing or lifting of flame should occur.

air shutter and lock screw

If flame needs to be adjusted:

Loosen the lock screw on the air shutter located at the rear of the broil burner. Adjust the air shutter as needed. Tighten lock screw.

24.Turn the oven control knob to “OFF” or press the “OFF/CANCEL” pad.

You have just finished installing your new range. To get the most efficient use from your range, read your Use & Care Guide.

Keep Installation Instructions and Guide

close to range for easy reference.

The instructions will make installing the range in another home as easy as the first installation.

Gas conversions

Gas conversions (from Natural gas to L.P. gas; or from L.P. gas to Natural gas) must be done by a qualified installer.

WARNING

Fire Hazard

Shut off gas supply line valve.

Make all conversions before turning gas supply valve back on.

Failure to follow these instructions can result in explosion, fire or other injury.

L.P. gas conversion

1.Complete installation sections A-C (Pages

4-5) before converting cooktop to L.P. gas. Check that main gas supply line has been shut off and the power supply cord is disconnected.

pressure regulator

plastic cover

pressureNatural regulator

plastic cover

L.P.

cap

washer

Nat. gas L.P. gas

DO NOT REMOVE THE PRESSURE REGULATOR.

2.Pressure regulator: Remove storage drawer and locate pressure regulator at back of range. Remove plastic cover. Turn cap marked “N” on front of pressure regulator counterclockwise with a wrench to remove. Do

Not disturb or remove the spring beneath the cap. Turn the cap over and reinstall cap on regulator so that the letters “L.P.” are visible. Replace plastic cover over cap.

Page 7