Installation.
•Carefully remove the extractor hood and the components from the packaging.
•Remove the grease filter ( see page 5).
•Draw a fine vertical line on the wall from the
•Draw another line, horizontal this time, where the bottom edge of the hood should be. (A minimum distance be- tween the hob and the hood of 750mm is recommended.)
CEILING MOUNTING
TEMPLATE
CUT TEMPLATE
ALONG LINE
HOOD MOUNTING
TEMPLATE
VETICAL LINE FROM
HOB CENTRE TO CEILINGHORIZONTAL LINE
750
•For mounting the 3 chimney brack- ets, drill 6 holes, 5mm diameter and 45mm deep into the wall as indicated on the mounting template.
•For mounting the extractor hood, drill 2 holes, 8mm in diameter and 60mm deep as indicated on the mounting tem- plate.
•Once all the holes have been drilled the templates must be removed.
•To attach the chimney mounting brack- ets push the 5mm wall plugs through the bracket holes and then insert the plugs together with the brackets into the wall holes and fasten securely.
•Push the larger wall plugs into the hood mounting holes ensuring that they are flush with the surface.
•Partially screw two 6mm screws into the wall plugs leaving them to protrude about 10mm.
10mm
•Take the template card and separate the ceiling mounting template from the hood mounting template by cutting along the indicated line.
•Using masking tape, stick the ceiling mounting template to the wall directly below the ceiling and centered on the vertical line.
•In a similar fashion stick the hood mount- ing template on the wall ensuring that the
•Lift and hang the extractor hood onto the two protruding screws through the key- hole slots provided at the top of the ex- tractor hood frame.
•Place slotted washers between the ex- tractor hood frame and the protruding screw heads
•Align the extractor hood ‘V’ notch with the vertical centre line and align the body of the hood with the horizontal line be- fore tightening the
two screws.
Page 4