Broan RM61000EX manual Operation, Halogen Bulbs, Controls, Hot

OPERATION
	LIGHT		BLOWER
Controls	SWITCH	BLOWER	ON / OFF
			SWITCH
		SPEED
The hood is operated using the slide controls
		CONTROL
under the front edge of the hood.
The light switch turns the halogen lights on
and off.
The blower on / off switch turns the blower on
to the running speed set by the blower speed			PILOT
control. The blower must be turned on and off			LAMP
using this switch.
The blower speed control changes the speed
of the blower from 1 to 3 position.

The pilot lamp lights up whenever the blower is on.

HEAT SENTRY™

Your hood is equipped with a HEAT SENTRY™ thermostat. This thermostat is a device that will turn on or speed up the blower if it senses excessive heat above the cooking surface.

1)If blower is OFF - it turns blower ON to HIGH speed.

2)If blower is ON at a lower speed setting - it turns blower up to HIGH speed. When the temperature level drops to normal, the blower will return to its original setting.

WARNING

The HEAT SENTRY thermostat can start the blower even if the hood is turned OFF. When this occurs, it is impossible to turn the blower OFF with its switch. If you must stop the blower, do it from the main electrical panel.

HALOGEN BULBS

This range hood requires 2 or 4 halogen bulbs (Type JC, 12Volt, 20Watt Max, G-4 Base).

ALWAYS SWITCH OFF THE ELECTRICITY SUPPLY BEFORE CARRYING OUT ANY OPERATIONS ON THE APPLIANCE.

To change bulbs:

1.Loosen the ring nut by turning it counterclockwise.

2.Pull the bulb downwards to remove - DO NOT ROTATE. CAUTION: BULB MAY BE

HOT!

3.Replace with Type JC, 12Volt, 20Watt Max, G-4 Base halogen bulb. Do not touch replacement bulb with bare hands!

-9 -

RING NUT