Broan IEX170 manual Read and Save These Instructions

Page 2

READ AND SAVE THESE INSTRUCTIONS

WARNINGWARNING

SUITABLE FOR USE IN HOUSEHOLD COOKING AREA.

TO REDUCE THE RISK OF FIRE, ELECTRICAL SHOCK, OR INJURY TO PERSONS, OBSERVE THE FOLLOWING:

1.Use this unit only in the manner intended by the manufacturer. If you have questions, con- tact the manufacturer at the address or tele- phone number listed in the warranty.

2.Before servicing or cleaning unit, switch power off at service panel and lock service panel to prevent power from being switched on accidentally.When the service disconnecting means cannot be locked, securely fasten a prominent warning device, such as a tag, to the service panel.

3.Installation work and electrical wiring must be done by a qualified person(s) in accordance with all applicable codes and standards, includ- ing fire-rated construction codes and stan- dards.

4.Sufficient air is needed for proper combustion and exhausting of gases through the flue (chim- ney) of fuel burning equipment to prevent backdrafting. Follow the heating equipment manufacturer’s guidelines and safety stan- dards such as those published by the National Fire Protection Association (NFPA), and the American Society for Heating, Refrigeration and Air Conditioning Engineers (ASHRAE), and the local code authorities.

5.When cutting or drilling into wall or ceiling, do not damage electrical wiring and other hidden utilities.

6.Ducted fans must always be vented to the out- doors.

7.Do not use this unit with any solid-state speed control device.

8.To reduce the risk of fire, use only steel ductwork.

9.This unit must be grounded.

TO REDUCE THE RISK OF A RANGE TOP GREASE FIRE:

A.Never leave surface units unattended at high settings. Boilovers cause smoking and greasy spillovers that may ignite. Heat oils slowly on low or medium settings.

B.Always turn hood ON when cooking at high heat or when cooking flaming foods.

C.Clean ventilating fans frequently. Grease should not be allowed to accumulate on fan or filter.

D.Useproperpansize.Alwaysusecookwareappropriate for the size of the surface element.

TO REDUCE THE RISK OF INJURY TO PER- SONS IN THE EVENT OF A RANGE TOP GREASE FIRE, OBSERVE THE FOLLOWING:*

1.SMOTHER FLAMES with a close-fitting lid, cookie sheet, or metal tray, then turn off the burner. BE CAREFUL TO PREVENT BURNS. If the flames do not go out immediately, EVACU-

ATE AND CALL THE FIRE DEPARTMENT.

2.NEVER PICK UP A FLAMING PAN - You may be burned.

3.DO NOT USE WATER, including wet dishcloths or towels - violent steam explosion will result.

4.Use an extinguisher ONLY if:

A.You know you have a Class ABC extin- guisher and you already know how to op- erate it.

B.The fire is small and contained in the area where it started.

C.The fire department is being called.

D.You can fight the fire with your back to an exit.

*Based on “Kitchen Fire Safety Tips” pub- lished by NFPA.

CAUTION

1.To reduce risk of fire and to properly exhaust air, be sure to duct air outside. Do not vent exhaust air into spaces within walls or ceilings or into attics, crawl spaces, or garages.

2.Take care when using cleaning agents or detergents.

3.Avoid using food products that produce flames under the Range Hood.

4.For general ventilating use only. Do not use to exhaust hazardous or explosive materials and vapors.

5.To avoid motor bearing damage and noisy and/ or unbalanced impellers, keep drywall spray, construction dust, etc. off power unit.

6.Your hood motor has a thermal overload which will automatically shut off the motor if it becomes overheated.The motor will restart when it cools down. If the motor continues to shut off and restart, have the hood serviced.

7.For best capture of cooking impurities, the bottom of the hood should be a minimum of 24" and a maximum of 30" above the cooking sur- face.

8.Thre installers are recommended because of the large size and weight of this hood.

9.Please read specification label on product for further information and requirements.

- 2 -

Image 2
Contents Model IEX170 Read and Save These Instructions Prepare the Hood Install the Ductwork Exterior Blower SelectionInstall Support System Install Discharge Collar Connect Decorative FlueInstallation of Glass Connect DuctworkWiring Mount Hood to Support FrameGlass Cleaning MaintenanceHood Cleaning Grease FiltersControls OperationHalogen Bulbs Fuse Replacement WarrantyLisez ET Conservez CES Instructions AvertissementsPreparez LA Hotte Installation DU Systeme D’EVACUATION Selection Unite ExterieureInstallation DU Systeme DE Support PartieInstallation DU Collier D’EVACUATION Assemblage DU Conduit DecoratifMontage DE LA Vitre Connexion DU Systeme ’EVACUATIONInstallation Electrique Montage DE LA Hotte SUR LA Structure DE SupportNettoyage de votre hotte EntretienFiltres anti-graisse Ampoules Halogenes CommandesFonctionnement Remplacement Fusible GarantieLEA Y Conserve Estas Instrucciones AdvertenciaPrepare LA Campana Selección DE LA Centralita Externa Instalacion DEL Tubo DE ExtraccionInstalacion DEL Sistema DE Sujecion Instalacion DEL Tubo Decorativo Instalacion DEL Casquillo DE Union CON EL TuboMontaje DEL Cristal Tubo DE Extraccion DE HumosMontaje DE LA Campana AL Armazón DE Soporte Instalacion ElectricaLimpieza de la campana MantenimientoFiltros antigrasa Limpieza del cristalMandos FuncionamientoLamparas Halogenas Sustitucion Fusible GarantiaService Parts DescriptionListe Pieces DE Rechange Part N DescriptionLista DE Piezas DE Recambio CÓD. N Pieza N DescripciónModel IEX170 04306855